Parts for Kenmore 911.3548810 (9113548810, 911 3548810): Control Panel Parts

This replacement screw secures appliance components so panels, brackets, and assemblies stay tight and aligned. Replace stripped or missing hardware to eliminate rattles and keep your unit assembled safely and correctly.

• Fastens panels, brackets, or components to the appliance frame
• Restores a secure fit when the original screw is lost, stripped, or corroded
• Helps prevent vibration noise and movement during operation
• Supports proper alignment of trim and assemblies

• Disconnect power; for gas units, also shut off the gas supply
• Use the correct driver to avoid stripping the head; do not overtighten
• Inspect and address damaged mating threads, clips, or brackets before reinstalling
• Refer to your model's parts diagram to confirm location and quantity

ST10-16 X 7/16"

This replacement screw secures appliance components so panels, brackets, and assemblies stay tight and aligned. Replace stripped or missing hardware to eliminate rattles and keep your unit assembled safely and correctly.

• Fastens panels, brackets, or components to the appliance frame
• Restores a secure fit when the original screw is lost, stripped, or corroded
• Helps prevent vibration noise and movement during operation
• Supports proper alignment of trim and assemblies

• Disconnect power; for gas units, also shut off the gas supply
• Use the correct driver to avoid stripping the head; do not overtighten
• Inspect and address damaged mating threads, clips, or brackets before reinstalling
• Refer to your model's parts diagram to confirm location and quantity

Includes 12 washers.

Color: Black

This control shield is a protective trim piece that mounts behind the control console to shield electronics and switches from heat, spills and grease. It helps preserve the range/stove control board and maintains safe operation. What it does:

• Shields the control console and electronic components from heat and cooking splatter
• Helps prevent premature wear or heat-related damage to switches and the control board
• Restores proper fit/finish to the console area when the original shield is cracked, warped or missing
• Commonly replaced when the console shows burn marks, melted plastic or when controls become exposed

• One control shield

• Disconnect power to the appliance before beginning any work
• Remove control console trim or back access panel per manufacturer instructions to reach the shield
• Handle edges carefully; sheet metal may be sharp
• Reassemble panels and controls operate normally after reinstall