Parts for Whirlpool KFGG500EWH8: Control Panel Parts

Color: White  Note: Left side endcap

White plastic end cap that covers the right side panel edge of your range. Replaces cracked, broken, or missing endcaps to restore a finished appearance.

Replace your range control panel if buttons don't respond, the display is blank, or settings won't change. Restores full oven and cooktop control.

Gas range won't ignite or no clicking when preheating? The spark module generates sparks to ignite burners. Intermediate repair, requires panel access.

Rear cover panel for gas ranges. Replaces cracked, damaged, or missing covers on the back of your range. Restores appearance and protects components.

Metal heat shield that protects range components from direct heat damage. Installs near oven cavity. Replace when original is warped, cracked, or missing.

This control board is the electronic Maxwell gas control used to manage ignition and flame for a single gas burner or oven circuit. It restores proper control logic so the appliance can ignite and maintain heat safely. What it does:

• Regulates gas valve timing and ignition sequencing for a single gas circuit
• Controls spark/igniter commands and monitors flame safety signals
• Common symptoms include no ignition, intermittent sparking, continuous clicking, or no heat

• One control board (Maxwell single gas) as shown

• Disconnect electrical power (and gas supply where applicable) before starting work
• Handle the board by the edges and avoid contact with electronics or terminals
• Verify wiring matches the original and secure all connectors before testing

This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.

• Fastens panels, brackets, covers, or internal parts to the chassis or frame
• Helps maintain alignment and support, reducing rattle, vibration, or looseness
• Replaces missing or damaged screws that have backed out, broken, or stripped
• Restores secure mounting after service when original hardware is lost

• Disconnect power; shut off water or gas supplies before servicing
• Use the correct driver; start threads by hand to avoid cross-threading
• Match length and thread to the original location; do not substitute with longer hardware
• Tighten snugly; do not overtighten into plastic or thin metal

If your gas range touch pad buttons aren't responding or display is unresponsive, this membrane switch fixes control panel issues. Moderate DIY repair.

This replacement screw secures appliance panels and components so they stay tight and aligned during use. Replacing a missing or damaged screw restores a solid fit and helps eliminate rattles, loose trim, or shifting parts.

• Fastens brackets, panels, trim, or components to the appliance chassis
• Helps correct loose or missing hardware after vibration or service
• Replaces stripped, rusted, or broken screws
• Can reduce rattling noises or misaligned parts caused by missing fasteners

• Disconnect power; for gas appliances, also shut off the gas supply
• Support the part being fastened; start threads by hand to avoid cross-threading
• Use the correct driver size; tighten snugly without overtightening
• Replace hardware with the exact part number to ensure proper fit

Size: 8-18 x 1/2 inch.