Parts for Ge ZET1DJ2SS: Control Panel & Upper Door Parts

Fix a stuck or misaligned oven drawer with this slider assembly base. Restores smooth gliding action when drawers won't open or close properly.

Protective cover for your wall oven's electronic touch board assembly. Replace if cracked, broken, or missing to restore the clean appearance of your control panel.

Fix a stuck or misaligned oven drawer with this slider assembly base. Restores smooth gliding action when drawers won't open or close properly.

Spacer that fits behind oven door handles to ensure proper alignment and fit. Replace if cracked, missing, or worn to restore a snug, finished appearance.

Replace your oven door panel lining if cracked, discolored, or damaged. This interior trim component installs on the door assembly for a finished look.

Seals your wall oven door to retain heat and improve efficiency. Replace if worn, cracked, or no longer sealing properly. Confirm fit with your model number.

Upper window pack assembly that replaces a cracked or damaged refrigerator door window panel, restoring appearance and helping protect the components behind the outer window. What it does:

• Replaces the upper door window pack to restore a clear, finished exterior on the appliance door.
• Addresses visible damage symptoms such as cracked, scratched, cloudy or broken window panels.
• Protects internal door components from exposure to moisture and debris.
• Matches the OEM-style mounting points for a like-for-like replacement when used with the correct model parts.

• Disconnect power and remove food from the door area before starting any repair.
• Handle the window pack carefully; wear cut-resistant gloves and eye protection when removing broken or cracked pieces.
• Remove any trim or fasteners per the appliance's service instructions; retain mounting screws and gaskets as needed.
• Refer to the OEM service manual or diagram for model-specific removal and reassembly steps.

Upper hinge receiver for oven doors. Secures the door hinge assembly to the cabinet frame. Replace if cracked, broken, or missing for proper alignment.

Mounting screw secures panels, trim, and brackets inside your oven. Replace if lost, stripped, or damaged during service to keep components aligned.

ST10-16 X 7/16"

A small replacement spring wiper that restores proper contact pressure and wiping action on the appliance component it services. Replaces a worn or broken wiper spring to help maintain consistent performance and reliable operation. What it does:

• Provides tension and a wiping contact surface where the original spring wiper has worn or failed
• Restores consistent electrical/contact or mechanical wiping action that can affect operation
• Commonly replaced when loose, bent, broken, or when intermittent contact is observed
• Helps prevent arcing, poor contact, or inconsistent component movement when functioning correctly

• One spring wiper

• Evaluate the surrounding components and match before installing; replace only the part(s) explicitly specified
• Use proper tools and avoid bending or overstretching the spring during installation
• Disconnect power to the appliance before accessing or replacing electrical/contact components

Oven door not communicating properly? This door signal harness restores electronic communication between the door and control board. Easy DIY fix.

Wire harness assembly connecting sail switch and temperature probe in wall ovens. Replace if wires are frayed, connectors damaged, or harness is worn.

Wire harness connecting relay board to sensor in wall ovens. Replace if wires are frayed, connectors damaged, or harness is melted or broken.

LED ribbon connector for electric wall ovens. Connects LED lighting strips to the control board. Replace if cracked, corroded, or causing loose connections.