Parts for Ge PVM9179DF2BB: Control Parts

This tapping pan-head screw secures interior panels and components in appliances, providing a low-profile head and threads that form into metal for a firm hold. It's a direct-fit fastener for repairs and replacements. What it does

• Fastens panels, brackets and small appliance components where a self-tapping screw is required
• Pan-head profile gives a flush, low-profile finish that resists snagging
• Threads cut into mating metal to create a secure attachment without a nut
• Commonly used where sheet-metal or thin-frame fastening is needed

• One tapping pan-head screw

• Use the correct screwdriver bit that matches the screw recess to avoid stripping
• Start in a pilot hole or with light initial pressure to ensure proper thread formation
• Tighten until snug; do not over-torque — overtightening can strip threads or deform panels
• Wear eye protection when working with metal fasteners and sheet metal

This part is a control board that is made for use on microwave units. The purpose of this part is to control all of the appliance functions. This includes heating, lighting, and turntable operation.When this part goes bad, the microwave will not work in some way or at all. This includes any of the functions including cooking properly, turning the lights on and off, or operating the turntable. This specific control board is compatible with microwaves that are manufactured by the General Electric brand. This includes the Hotpoint and RCA brands also. It is sold individually is comes directly from the manufacturer as a high-quality replacement part.

This control knob restores safe, easy operation of a stove or range control. It replaces a cracked, melted, or missing knob so you can adjust burners or oven settings with a secure grip and clear feel. What it does:

• Fits onto the appliance control shaft to select burner or oven settings
• Replaces damaged, loose, stripped, melted, or missing knobs
• Provides a firm, tactile grip for precise control
• Helps prevent accidental changes by seating securely on the shaft

• Disconnect power (and gas, if applicable) before servicing the appliance
• Remove the old knob by pulling it straight off the control shaft
• Align the knob with the control shaft splines and push firmly until fully seated
• If the knob does not install easily, verify shaft alignment and do not force.