Parts for Ge GTW585BSV3WS: Controls & Backsplash Parts

The GE Badge is an OEM part for GE washing machines. It is an emblem installed on the exterior of the washer that identifies the manufacturer and brand. Beyond aesthetics, the badge also demonstrates authenticity and quality assurance for the appliance.

Causes of a bad badge can include damage from impact or weathering over time, loss of adhesion to the outer casing, or fading/wear of printed graphics.  

Symptoms of a bad badge include:

• Missing or loose badge that is no longer securely attached
• Faded or illegible print that fails to display the brand
• Cracks or pieces breaking off the badge surface

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

Washer won't start or motor won't run? The start capacitor energizes the drive motor. Accessible repair requiring removal of electrical board.

Washer won't start or motor won't run? The start capacitor energizes the drive motor. Accessible repair requiring removal of electrical board.

This left backsplash support secures the left side of a range or stove backsplash, keeping the backsplash aligned and stable for safe, reliable operation. It replaces a bent or broken support to restore proper fit and appearance. What it does:

• Holds and supports the left edge of the backsplash to prevent sagging or separation
• Restores proper alignment so control panels and trim sit flush
• Helps stop rattling or vibration caused by a damaged support
• Commonly replaced when the support is bent, cracked, or missing

• Install with the appliance unplugged and controls off; disconnect power at the breaker for electric ranges.
• Depending on model, you may need to remove the backsplash trim or rear panel to access mounting points.
• Use correct-size fasteners and verify secure attachment; avoid overtightening to prevent cracking.

This right-side backsplash support secures the range's backsplash to the cooktop, restoring proper alignment and stability so the backguard sits firmly and reduces wobble or gaps. Designed to fit the OEM mounting points. What it does

• Holds the right side of the backsplash in place so the backguard stays aligned with the cooktop
• Prevents the backsplash from leaning, rattling, or separating from the range
• Restores proper mounting after impact, wear, or missing/broken fasteners
• Works with the range's existing screws and mounting brackets to re-establish a solid fit

• One right-side backsplash support

• Disconnect power to the appliance before starting any repair
• Remove the backguard or access panel per manufacturer instructions to reach mounting area
• Use basic hand tools (screwdriver/socket) to remove and replace fasteners; keep original screws if reusable
• Watch for sharp sheet-metal edges and wear safety gloves and eye protection

Selector knob for washer control panels. Replace this part if your current knob is cracked, broken, loose, or missing from the control interface.

Fix washer electrical failures with this jumper harness. Restores connector-to-connector wiring between components when original harness is worn or damaged.

Main wiring harness for washer control systems. Connects electrical components throughout the machine. Replace if wires are frayed, connectors damaged, or harness is broken.

8-18 hi/lo 5/8

Fastens panels, brackets, and trim to appliance cabinets. Replace this screw when the original is missing, stripped, or damaged during service work.