Parts for Ge WNCK2050H2WC: 01 - Controls & Backsplash Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Black. Right hand side

Fix washer overfilling and water spilling over the tub with this pressure switch. Simple 3-wire installation stops overflow issues. DIY-friendly repair.

Specs: 8 - 18 ab trt 5/8 s

Power line filter sits between household AC and washer's internal wiring. Replace when cracked, corroded, or causing breaker trips due to electrical noise.

Fix a washer that won't start, advance cycles, or respond to buttons with this control board assembly. Direct replacement for common cycle control issues.

Connector component for washer stacking kits. Installs between stacked units to secure appliances together. Replace if cracked, broken, or missing.

Size: 8-18 b.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Stainless steel hex washer head screw for securing appliance panels, brackets, and trim. Replace missing, stripped, or corroded fasteners during repair.

Harness to corset & shifter

These GE screws are a 12-pack of OEM replacement parts responsible for securing and fastening various components and panels in a GE range or oven. These screws are designed with a hexagonal head, which allows for the use of a compatible wrench or socket for tightening. They are commonly used to attach sheet metal panels, brackets, and other parts within the appliance, ensuring that these components remain securely in place during operation.

This part fixes the following symptoms:

• Loose or wobbly parts or panels within the appliance's interior or exterior
• Panels or components falling out of place, creating gaps or exposing internal parts
• Unusual noises or rattling sounds during the appliance's operation

The GE screws can also be used on Hotpoint, RCA, and Kenmore/Sears appliances.

Secures washer hoses at pump, tub, and valve connections to prevent leaks and hose blow-offs. Replace worn or missing clamps for a tight seal. Confirm fit.

This funnel shower head directs water flow inside the dispenser, helping water reach the glass or icemaker chute reliably. It replaces a worn or cracked funnel to restore proper water direction and reduce splashing. What it does:

• Channels dispenser water so it flows where expected and limits splatter
• Replaces cracked, warped, or clogged funnel pieces that divert flow
• Restores secure fit inside the dispenser area for consistent performance
• Reduces leaks and dripping caused by damaged funnels

• Disconnect power and shut off water to the appliance before starting
• Remove the old funnel carefully to avoid damaging surrounding trim
• Press or snap the new funnel into place until fully seated; do not force
• Check connections and test dispenser for leaks after reassembly

Fix slow-filling or constantly running water issues with this washer water inlet valve. Controls hot, cold, and warm water flow. DIY repair in 30-60 minutes.

12-pack of inlet hose washers for washers and washer dryer combos. Replace cracked, worn, or missing washers to prevent leaks at water connections.

Water intake hose assembly for washers. Connects water supply to inlet valve. Replace if cracked, leaking, worn, or damaged to restore proper water flow.

Connects the pressure switch to the tub in top-load washers. Replace if cracked, punctured, or brittle to restore proper water level monitoring.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.