Parts for Frigidaire FPIC3677RFC: Controls / Induct Generators|Cfpic3677rfc.Svg Parts

This wiring harness connects refrigerator control components to deliver power and signal paths between the main control, sensors and subsystems. Restores electrical connections so controls and accessories operate reliably. What it does:

• Carries power and signals between the main control board and connected sensors/subassemblies
• Replaces a damaged or frayed harness that can cause intermittent electrical faults
• Commonly used when controls, lights, dispenser or ice-maker stop responding
• Helps eliminate shorts or open circuits caused by broken wires or connectors

• Disconnect power to the appliance before servicing to avoid shock or damage
• Handle connectors by the plastic bodies; avoid pulling on wires
• Route harness the same way as the original and secure clips/retainers

This control mounting hex nut secures the burner or oven control to the control panel, keeping the shaft stable so the knob turns smoothly and the switch stays properly aligned.

• Threads onto the control/infinite switch or thermostat bushing to fasten it to the panel
• Prevents the control from rotating or shifting when the knob is turned
• Replace if the original nut is missing, stripped, rounded, or corroded
• Common signs: loose or wobbly knob, switch spins in the panel, or misaligned knob indexing

• Disconnect power; for gas appliances, also shut off gas before servicing
• Pull off the knob and any trim; support the control body from behind the panel while removing/installing the nut
• Start the new nut by hand to avoid cross-threading; tighten snugly with the correct-size wrench—do not overtighten
• The control sits square in the panel and the knob operates smoothly before restoring power

The Terminal Block Kit is an OEM part for Frigidaire appliances, typically used for connecting house power to various electrical appliances like ranges and dryers. This kit includes includes screws, nuts, and a unique terminal block. It plays a critical role in the power supply system by providing a reliable connection point for the appliance's main power cord, preventing loose connections and potential electrical hazards.

Symptoms of a bad Terminal Block Kit include:

• Signs of burning or melting at the connection points,
• Flickering power or intermittent operation of the appliance,
• A burning smell from the appliance area.

Causes of terminal block failure often involve loose connections that can lead to arcing and overheating, improper installation, or general wear and tear that degrades the integrity of the electrical contacts.

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

This replacement screw is a single fastener used to secure appliance panels and components. It provides a simple, durable connection for routine repairs and maintenance where the original screw has been lost or damaged. What it does:

• Secures trim, panels, brackets, or small components in place
• Restores proper fit where a missing or stripped screw causes rattling or loose parts
• Matches OEM fit when used as the specified replacement screw
• Helps maintain appliance safety and alignment when installed correctly

• Use the correct screwdriver or bit to avoid cam-out and damage
• Tighten until snug; avoid overtightening to prevent stripping or cracking
• Disconnect power before servicing if the screw secures electrical components
• Compare to the original part before installation if fit or length is critical

This electrical harness connects the range/oven's control components, routing power and signals so the appliance operates safely and reliably. Replacing a damaged harness restores proper electrical connections and consistent control response. What it does:

• Routes power and signal connections between the control board and switches/elements
• Restores reliable electrical continuity when original wiring is frayed or damaged
• Helps eliminate intermittent operation, failure to start, or unresponsive controls
• Prevents shorting and arcing caused by exposed or broken wires

• Disconnect power at the breaker before servicing to avoid shock or injury
• Verify harness routing and connector orientation before final installation
• Inspect connectors and mounting points for damage; replace any burned or corroded fasteners