Parts for Ge GUD27ESSJ0WW: Controls Parts

The Drive Motor and Control Board Kit is an OEM part for GE washers. It includes both the drive motor, which powers the movement of the wash basket or tub during cycles, as well as the control board which communicates with and regulates the functions of the motor. This integrated kit works seamlessly to provide the necessary wash and spin motions.

Symptoms of a bad drive motor and control board kit include: 

• The washer tub not turning or agitating during wash cycles
• Inability to advance cycles  
• Electrical issues such as sparking or burning smells
• Fault codes displayed or cycles stopping prematurely

Causes can be normal wear and tear over time, water damage corrupting electronic components, or damage from foreign objects getting lodged in the motor or drive mechanism.

This OEM GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.
 

Support board for laundry center units. Provides structural support inside the cabinet. Replace if cracked, broken, or damaged from wear or impact.

A small replacement hose clip that secures flexible appliance hoses to fittings to help prevent leaks and disconnections. Fits commonly used appliance hose connections to restore a secure seal and reliable water flow. What it does:

• Secures a water or drain hose to a barb or fitting to prevent the hose from coming loose
• Helps stop leaks and drips caused by loose or slipping hoses
• Prevents hose movement and rubbing that can lead to wear or abrasion
• Useful when a hose slips off during operation or after maintenance

• Disconnect power and shut off the water supply before servicing the appliance
• Use appropriate hand tools (needle-nose pliers or hose clamp pliers) to open and seat the clip
• Position the clip over the fitting and tighten until the hose is snug and secure; avoid over-tightening
• Replace only with the correct OEM-style clip for a proper fit

Dryer won't power on or trips breaker? Replace the terminal block and ground strap assembly to restore safe electrical connections. Easy DIY repair.

Replacement strain relief bracket that secures the power cord at entry point. Needed when bracket is cracked, broken, or missing to restore safe cord routing.

Replace missing or stripped mounting screws in your washer dryer combo. This 12-pack secures panels, components, and internal parts during assembly or repair.

Protective cover for the fuse and terminal block in your laundry center. Replace if cracked, broken, or missing to shield electrical connections.

Control board enclosure cover for laundry centers and washer dryer combos. Replaces cracked, broken, or missing enclosure that protects electronics.

Fix a washer dryer combo that won't start or has no power with this fuse harness assembly. Protects electrical circuits from damage. DIY repair.

If your washer overfills, underfills, or won't advance past fill, this electronic water level pressure switch monitors tub pressure to control fills.

Washer not filling properly or overfilling? This pressure switch harness connects the water level sensor to control board. Moderate 30-minute repair.

Wire harness extension assembly for laundry centers. Replaces damaged, frayed, or broken wiring harness extensions. Essential for safe electrical connections.

Includes 12 screws. Size: 8-18 ab.

Replacement mounting screw for dryer panels, brackets, and components. Needed when screws are missing, stripped, or damaged during repairs or disassembly.