Parts for Ge GUD27GSSJ1WW: Controls Parts

Size: 8 - 18 ab.

The Drive Motor and Control Board Kit is an OEM part for GE washers. It includes both the drive motor, which powers the movement of the wash basket or tub during cycles, as well as the control board which communicates with and regulates the functions of the motor. This integrated kit works seamlessly to provide the necessary wash and spin motions.

Symptoms of a bad drive motor and control board kit include: 

• The washer tub not turning or agitating during wash cycles
• Inability to advance cycles  
• Electrical issues such as sparking or burning smells
• Fault codes displayed or cycles stopping prematurely

Causes can be normal wear and tear over time, water damage corrupting electronic components, or damage from foreign objects getting lodged in the motor or drive mechanism.

This OEM GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.
 

A small replacement hose clip that secures flexible appliance hoses to fittings to help prevent leaks and disconnections. Fits commonly used appliance hose connections to restore a secure seal and reliable water flow. What it does:

• Secures a water or drain hose to a barb or fitting to prevent the hose from coming loose
• Helps stop leaks and drips caused by loose or slipping hoses
• Prevents hose movement and rubbing that can lead to wear or abrasion
• Useful when a hose slips off during operation or after maintenance

• Disconnect power and shut off the water supply before servicing the appliance
• Use appropriate hand tools (needle-nose pliers or hose clamp pliers) to open and seat the clip
• Position the clip over the fitting and tighten until the hose is snug and secure; avoid over-tightening
• Replace only with the correct OEM-style clip for a proper fit

Size: 8-32 t. Includes 12 screws.

This electronic water level pressure switch senses air pressure from the wash tub and tells the control when to start and stop filling. Replacing a failed switch restores proper fill levels and helps cycles advance reliably. What it does:

• Monitors tub water level via an air hose connected to the switch
• Signals the control to start/stop the inlet valves at the correct level
• Enables cycle progression by confirming empty/full status
• Common symptoms: won't stop filling, stops filling too soon, incorrect water level, or water-level error codes

• 1 electronic pressure switch

• Disconnect power and turn off water supply before servicing
• Access the switch in the control console or rear cabinet area (location varies by model)
• Move the pressure hose and wire connector(s) over one at a time; ensure airtight hose fit and proper routing without kinks
• Inspect the hose and air dome for cracks, kinks, or blockages; clear or replace if needed