Parts for Crosley CDG7300RW0: Controls / Top Panel Parts

The Main Control Board is an OEM part for Frigidaire dryers. It is the "brain" that regulates all dryer functions and features like sensor drying and temperature control.

Situated inside the dryer where it receives constant vibrations from spin cycles, the control board faces significant stresses over time. Causes of failure typically relate to standard component degradation.

Symptoms of a problematic main control board include:

• Unresponsive or non-functional controls
• Inability to select cycles or change temperature
• Dryer fails to start, heat or tumble clothes

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

This small pin secures the program selection knob to the dryer's control panel shaft. Replace if the control knob spins freely without changing settings or falls off the control panel.

Mounting bracket for dryer assembly. Secures internal components in proper position. Replace if bent, cracked, or broken to restore structural support.

Mounting bracket for dryer components. Secures and supports internal parts. Replace if bent, cracked, or broken to restore proper alignment and stability.

Pan head mounting screw for dryers. Secures internal components and panels. Replace if stripped, missing, or damaged during appliance maintenance.

This is the top panel that covers the upper portion of the dryer cabinet, providing a finished exterior surface and protecting internal components. It attaches to the dryer frame and typically lifts or slides off for service access. Replace this panel if it is dented, rusted, scratched, or warped.

Electrical harness assembly for dryers. Connects internal components and delivers power throughout the unit. Replace if wires are damaged or frayed.

This damper is the refrigerator air-control flap that regulates airflow between compartments to help maintain consistent temperatures and proper cooling. It replaces a worn or stuck damper to restore normal airflow and temperature balance. What it does:

• Opens and closes to direct cold air where needed between freezer and fresh-food sections
• Helps maintain even temperatures and prevents one compartment from getting too warm
• Common symptom: uneven cooling or warm fresh-food section despite running compressor
• Common symptom: damper stuck or not moving, causing poor temperature control

• Disconnect power to the appliance before starting any repair
• Remove interior panels to access the damper; use basic hand tools
• Handle the damper and any wiring harness carefully to avoid damage
• After installation, verify damper operation and allow time for temperatures to stabilize

Dryer not starting or power cutting out? A melted or corroded terminal block disrupts power flow. This 3-terminal block restores secure connections. DIY-friendly repair.

This factory 8-18 screw secures appliance panels, brackets, and components. Replace missing or stripped hardware to restore a tight, rattle-free assembly and dependable operation.

• Fastens components to frames, brackets, and covers
• Replaces missing, damaged, or rusted screws
• Helps reduce looseness, vibration, and rattling noises
• Restores proper alignment of panels and assemblies

• Disconnect power before servicing; shut off gas/water if applicable
• Start the screw by hand to avoid cross-threading; use the proper driver
• Tighten snugly—do not overtighten to prevent stripping metal or plastic