Parts for Electrolux EFDG317TIW1: Controls / Top Panel Parts

This user interface board is the control panel electronics that register button presses and display status so the appliance responds to your inputs. It restores touchpad and display functions for electronic controls. What it does:

• Receives and processes button/touch inputs from the control panel
• Drives the display and status indicators so settings and timers are visible
• Enables cycle start, option selection, and mode changes via the front controls
• Common symptom: unresponsive buttons, no display, or inability to start cycles

• Disconnect power to the appliance before servicing to avoid shock or damage
• Handle the board by the edges and avoid touching components or connector pins
• Verify connectors and ribbon cables seat fully; inspect for visible damage before replacing

This replacement door gasket seals the appliance door to maintain a tight, even seal that helps control temperature and prevent leaks. It restores proper door closure and reduces energy loss when the original gasket is cracked, torn, or hardened. What it does:

• Creates a continuous barrier between the door and cabinet to keep internal air in and outside air out
• Prevents water and air leaks that can lead to frost build-up or inconsistent temperatures
• Improves appliance efficiency by reducing cold/hot air exchange across the door
• Helps the door latch and close evenly for reliable operation

• One door gasket/seal

• Disconnect power to the appliance before starting any repairs
• Remove the old gasket by gently pulling from the door frame; clean the gasket channel before installing the new seal
• Work around the door evenly, pressing the new gasket into the channel to avoid stretching or twisting
• If the gasket is tight after install, allow time for it to relax into place; use care with sharp tools to avoid damage

This top panel in white restores the oven/stove's upper exterior, improving appearance and protecting internal components from spills and debris. It's a direct-replacement exterior shell piece designed to match original fit and finish. What it does:

• Replaces a cracked, warped, dented, or discolored upper cabinet panel
• Protects control housing and internal components from grease, spills, and dust
• Restores a flush, finished look to the appliance top and backguard area
• Helps maintain proper alignment for control and trim pieces

• Disconnect power to the appliance before beginning any work
• Typical removal requires removing screws and lifting the old panel straight out; keep mounting hardware
• Handle edges carefully to avoid cuts and protect the painted finish during installation

This factory 8-18 screw secures appliance panels, brackets, and components. Replace missing or stripped hardware to restore a tight, rattle-free assembly and dependable operation.

• Fastens components to frames, brackets, and covers
• Replaces missing, damaged, or rusted screws
• Helps reduce looseness, vibration, and rattling noises
• Restores proper alignment of panels and assemblies

• Disconnect power before servicing; shut off gas/water if applicable
• Start the screw by hand to avoid cross-threading; use the proper driver
• Tighten snugly—do not overtighten to prevent stripping metal or plastic