Parts for Electrolux EFME427UIW0: Controls / Top Panel Parts

The User Control and Display Board is an OEM replacement part for Frigidaire electric dryers. This electronic board centrally controls and monitors dryer functions while displaying cycle status and options on the user interface panel.

Causes of a bad control board can include moisture damage over time that corrodes connections or causes shorts. The board may also fail due to repeated thermal cycling inducing stress cracks in solder joints and components. 

Symptoms of a bad control board include:

• Non-responsive or unresponsive buttons
• No display illumination or cycling through dryer options  
• Inability to advance through cycles or start the dryer
• Appearing locked or frozen on one screen

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

This top panel in white restores the oven/stove's upper exterior, improving appearance and protecting internal components from spills and debris. It's a direct-replacement exterior shell piece designed to match original fit and finish. What it does:

• Replaces a cracked, warped, dented, or discolored upper cabinet panel
• Protects control housing and internal components from grease, spills, and dust
• Restores a flush, finished look to the appliance top and backguard area
• Helps maintain proper alignment for control and trim pieces

• Disconnect power to the appliance before beginning any work
• Typical removal requires removing screws and lifting the old panel straight out; keep mounting hardware
• Handle edges carefully to avoid cuts and protect the painted finish during installation

This wiring harness connects electrical components inside the appliance to restore reliable power and signal paths. It replaces a damaged or worn harness to stop intermittent power, unresponsive controls, or component failures. What it does:

• Carries power and control signals between modules and components
• Replaces frayed, broken, or corroded wiring that can cause intermittent operation
• Helps resolve symptoms such as no power to a circuit, lights or controls not working, or unexpected shutdowns
• Restores factory routing and connector fit for secure electrical connections

• One replacement wiring harness

• Disconnect power to the appliance before starting any work
• Match connector shapes and pin counts; do not force connectors into place
• Route harness along original clips and channels to avoid pinch points or heat exposure
• Test appliance functions after installation

This damper is the refrigerator air-control flap that regulates airflow between compartments to help maintain consistent temperatures and proper cooling. It replaces a worn or stuck damper to restore normal airflow and temperature balance. What it does:

• Opens and closes to direct cold air where needed between freezer and fresh-food sections
• Helps maintain even temperatures and prevents one compartment from getting too warm
• Common symptom: uneven cooling or warm fresh-food section despite running compressor
• Common symptom: damper stuck or not moving, causing poor temperature control

• Disconnect power to the appliance before starting any repair
• Remove interior panels to access the damper; use basic hand tools
• Handle the damper and any wiring harness carefully to avoid damage
• After installation, verify damper operation and allow time for temperatures to stabilize

This factory 8-18 screw secures appliance panels, brackets, and components. Replace missing or stripped hardware to restore a tight, rattle-free assembly and dependable operation.

• Fastens components to frames, brackets, and covers
• Replaces missing, damaged, or rusted screws
• Helps reduce looseness, vibration, and rattling noises
• Restores proper alignment of panels and assemblies

• Disconnect power before servicing; shut off gas/water if applicable
• Start the screw by hand to avoid cross-threading; use the proper driver
• Tighten snugly—do not overtighten to prevent stripping metal or plastic