Parts for Electrolux ELFG7637AW0: Controls / Top Panel Parts

The Board Assembly is an OEM part for Frigidaire dryers. It refers to the control/display circuit board located at the front of the dryer. This board handles input from the control panel buttons and displays, as well as communicating with all the dryer's electronic components including the timer, temperature sensors, heating elements, and motor.

Causes of a bad board can include moisture exposure from improper venting, power surges, normal wear over time, and impacts from accidental mishandling. 

Symptoms of a bad board assembly include:

• The dryer not turning on or powering up  
• Fault codes appearing on the display
• Inability to select cycles or temperatures
• Timer/sensor malfunctions preventing proper drying
• Intermittent operation issues

Replacing the board assembly with a Frigidaire OEM part restores full electronic functionality. This ensures reliable, safe drying. It is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore dryers.
 

This control knob replaces a worn, missing, or damaged round stove/range control knob to restore reliable setting selection and safe operation. It gives a simple, push-on replacement for a faded or broken original. What it does:

• Fits onto the appliance control shaft to select heat or function settings
• Restores a secure grip and clear tactile feedback when turning controls
• Commonly replaces knobs that are cracked, stripped, loose, or missing
• Helps prevent accidental setting changes from a damaged knob

• Disconnect power to the appliance (or shut off gas supply) before servicing
• Remove the old knob by pulling straight off the control shaft; align and push the new knob onto the shaft until fully seated
• If the knob does not fit, verify shaft/profile compatibility with your appliance before forcing

This metal top panel replaces the upper rear control housing on compatible Frigidaire ranges and stoves, restoring a secure mounting surface for controls and improving cabinet fit and appearance. Ideal for repairing bent, rusted, or damaged panels. What it does

• Replaces the upper rear housing that supports control knobs, switches and the backguard area
• Restores proper alignment and spacing between the cooktop and rear controls
• Stops light leaks and relieves stress from warped or bent panels
• Commonly used when the panel is dented, rusted, cracked, or has broken mounting tabs

• One top panel

• Disconnect power (and gas, if applicable) before starting any work
• Handle sharp sheet-metal edges with gloves; panel edges can be sharp
• Remove control knobs, backguard, or trim as required and save screws for reinstallation
• Align mounting tabs and secure with original hardware; test controls after reassembly

This top panel in white restores the oven/stove's upper exterior, improving appearance and protecting internal components from spills and debris. It's a direct-replacement exterior shell piece designed to match original fit and finish. What it does:

• Replaces a cracked, warped, dented, or discolored upper cabinet panel
• Protects control housing and internal components from grease, spills, and dust
• Restores a flush, finished look to the appliance top and backguard area
• Helps maintain proper alignment for control and trim pieces

• Disconnect power to the appliance before beginning any work
• Typical removal requires removing screws and lifting the old panel straight out; keep mounting hardware
• Handle edges carefully to avoid cuts and protect the painted finish during installation

This factory 8-18 screw secures appliance panels, brackets, and components. Replace missing or stripped hardware to restore a tight, rattle-free assembly and dependable operation.

• Fastens components to frames, brackets, and covers
• Replaces missing, damaged, or rusted screws
• Helps reduce looseness, vibration, and rattling noises
• Restores proper alignment of panels and assemblies

• Disconnect power before servicing; shut off gas/water if applicable
• Start the screw by hand to avoid cross-threading; use the proper driver
• Tighten snugly—do not overtighten to prevent stripping metal or plastic