Parts for Frigidaire FSG747GES1: 04 - Controls / Top Panel Parts

This clip is a small plastic retainer designed to secure trim and lightweight panels so they stay in place and reduce rattling or gaps. It restores proper fit and helps keep parts aligned for a finished look. What it does:

• Secures trim pieces, panels, or grill components to the appliance frame
• Prevents loose or rattling parts that can cause noise or misalignment
• Holds components in correct position so doors and panels close properly
• Replaces worn or broken clips that no longer grip reliably

• Remove power or disconnect the appliance before servicing when applicable
• Clip installs by snapping into pre-existing mounting hole or slot; no special tools usually required
• Inspect mating surfaces and replace any additional damaged fasteners for best fit

The Turn Start Switch is an OEM part for Frigidaire dryers. It is responsible for initiating the drying cycle when the switch is turned. This switch is a critical component that engages the dryer’s motor and starts the drying process, ensuring your clothes are dried effectively.

You should replace the turn start switch if it becomes faulty or unresponsive. Causes of a bad start switch can include regular wear and tear from frequent use, electrical issues, or damage due to excessive force or mishandling.

Symptoms of a bad turn start switch include:

• Dryer not starting when the switch is turned
• Intermittent starting issues
• The switch feeling loose or not engaging properly

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

This factory replacement screw secures panels, brackets, or trim on your appliance so parts stay tight and aligned. Swap in a new screw when one is missing or stripped to restore a solid, rattle-free fit.

• Fastens compatible panels, brackets, handles, or internal hardware
• Helps maintain proper alignment and stability
• Common fix for loose or wobbly handles/trim, rattling noises, or missing hardware
• Replace if threads are stripped, head is damaged, or corrosion is present

• Disconnect power before servicing; wear cut-resistant gloves
• Use the correct screwdriver or nut driver to avoid stripping
• Start threads by hand to prevent cross-threading
• Tighten until snug; do not overtighten

Color: white. This knob measures a little over 2 inches in diameter.

Color: white. Measures about 1-1/2 inches in diameter.