Parts for Kenmore 417.91102002 (41791102002, 417 91102002): Controls / Top Panel Parts

This factory 8-18 screw secures appliance panels, brackets, and components. Replace missing or stripped hardware to restore a tight, rattle-free assembly and dependable operation.

• Fastens components to frames, brackets, and covers
• Replaces missing, damaged, or rusted screws
• Helps reduce looseness, vibration, and rattling noises
• Restores proper alignment of panels and assemblies

• Disconnect power before servicing; shut off gas/water if applicable
• Start the screw by hand to avoid cross-threading; use the proper driver
• Tighten snugly—do not overtighten to prevent stripping metal or plastic

A small replacement retaining ring that secures internal components to restore proper alignment and reliable operation. Use this OEM-style ring when a worn or broken ring lets parts shift or rattle. What it does

• Holds shafts, trim, or small assemblies in place to prevent movement and rattling
• Helps maintain proper alignment of the associated component
• Can stop intermittent contact or noise caused by a loose part
• Prevents parts from slipping out of position during normal use

• Disconnect power (and water supply if applicable) before beginning any repair
• Access the affected assembly per your model's service instructions or diagram
• Use appropriate pliers or a small driver to remove and install the ring; avoid forcing parts
• Inspect surrounding seals, clips, and fasteners and replace any damaged items

This replacement pipe routes water where needed inside the appliance to restore proper flow and stop leaks. It's a direct-fit service tube for systems that use molded or bent piping to move water. What it does

• Channels water between internal components to enable normal operation
• Helps prevent water leaks and pooling when intact
• Commonly replaced when cracked, split, clogged, or disconnected
• Can resolve symptoms like visible leaks, water on the floor, or components not filling properly

• One replacement pipe

• Recommended for customers comfortable with basic appliance disassembly; refer to your model's service manual or IPL for the exact routing and clip locations
• Disconnect power and water supply before starting repair to avoid shock or flooding
• Inspect mounting clips, grommets, and seals and replace any damaged hardware to ensure a secure, leak-free fit

Fixes dryers with intermittent timing issues, unresponsive controls, or cycles that won't start. This electronic control board restores proper operation.

Pan head mounting screw for dryers. Secures internal components and panels. Replace if stripped, missing, or damaged during appliance maintenance.

Mounting bracket for dryer assembly. Secures internal components in proper position. Replace if bent, cracked, or broken to restore structural support.

Mounting bracket for dryer components. Secures and supports internal parts. Replace if bent, cracked, or broken to restore proper alignment and stability.

This damper is the refrigerator air-control flap that regulates airflow between compartments to help maintain consistent temperatures and proper cooling. It replaces a worn or stuck damper to restore normal airflow and temperature balance. What it does:

• Opens and closes to direct cold air where needed between freezer and fresh-food sections
• Helps maintain even temperatures and prevents one compartment from getting too warm
• Common symptom: uneven cooling or warm fresh-food section despite running compressor
• Common symptom: damper stuck or not moving, causing poor temperature control

• Disconnect power to the appliance before starting any repair
• Remove interior panels to access the damper; use basic hand tools
• Handle the damper and any wiring harness carefully to avoid damage
• After installation, verify damper operation and allow time for temperatures to stabilize