Parts for Bosch HBL8751UC/01: Convection Parts

This circular heating element sits around the oven's convection fan and supplies the heat used in convection modes. Replacing a failed ring heater restores fast, even convection baking and consistent temperature control. What it does:

• Provides the primary heat source for convection bake/roast by surrounding the fan
• Helps maintain even temperature and airflow during convection cycles
• Common fix when convection mode won't heat or preheats slowly
• Replace if the element is open, blistered, or visibly broken

• One ring-style convection heating element

• Disconnect power to the oven/range before servicing
• Access is typically from the rear or by removing the interior fan cover; note wire positions before removal
• Avoid bending the element; transfer any brackets as required and secure mounting screws
• Reconnect wires firmly and test operation before reinstalling panels

This genuine screw secures panels, brackets, and other components in your appliance. Replacing a missing, rusted, or stripped fastener restores a snug fit, reduces vibration, and helps keep assemblies properly aligned during daily use.

• Fastens panels, brackets, or covers to the appliance chassis
• Helps maintain alignment to reduce looseness and vibration
• Replaces missing, corroded, or stripped hardware

• Disconnect power and shut off water/gas before servicing
• Support the panel or component while removing the damaged screw
• Start the new screw by hand to avoid cross-threading, then tighten until snug—do not overtighten
• If the receiving clip or hole is stripped, repair or replace that hardware before reinstalling

This is a replacement mounting nut used to secure components on compatible Bosch appliances. It restores proper fastening to reduce movement and noise from loose connections. What it does:

• Secures panels, assemblies or brackets to prevent shifting during operation
• Restores proper clamp force where a stripped or missing nut causes looseness
• Helps eliminate rattling or vibration caused by unsecured parts
• Provides a direct replacement for the original fastener

• Turn off and unplug the appliance or shut off power at the breaker before servicing
• Use the correct-size wrench or socket to avoid rounding the nut
• Tighten to a snug fit; avoid over-tightening which can strip threads or damage parts