Parts for Ge CVE28DP4NDW2: Convertible Drawer Parts

This refrigerator thermistor senses internal cabinet temperature so the control board can maintain proper cooling. Replaces a failed sensor to help restore accurate temperature readings and steady cooling performance. What it does:

• Measures compartment temperature and sends readings to the control board
• Helps control intermittent compressor and fan cycles for steady temperatures
• Can cause warm or over-cooled compartments, frequent cycling, or temperature error codes when faulty
• Works as part of the fridge's thermostat/control system

• One refrigerator thermistor temperature sensor

• Disconnect power before servicing to avoid shock or damage
• Handle the sensor and wiring gently; avoid pulling on wires or connectors
• Access may require removing interior panels or trim—keep track of screws and fasteners

LED light assembly for refrigerator convertible or freezer drawer compartments. Replaces cracked, broken, or non-illuminating drawer lights.

Replacement fastener for refrigerator door handles. Secures handle to door with durable metal construction. Needed when original is cracked or broken.

Left-side mounting bracket for convertible drawer in bottom-mount refrigerators. Replaces cracked, broken, or missing brackets that fail to secure drawer.

Right-side bracket for convertible drawer assembly in bottom-mount refrigerators. Replaces cracked, broken, or missing brackets that no longer secure drawer.

Screw that secures the convertible drawer bracket inside your bottom-mount refrigerator. Replace if missing, stripped, or damaged during maintenance.

This set screw secures refrigerator components—most commonly door handles—to their mounting studs. Replacing a missing or stripped screw restores a solid, secure feel and helps prevent loose or wobbly handles.

• Locks the handle to its mounting stud to keep it tight and secure
• Helps resolve a loose, wobbly, sliding, or rattling handle
• Replaces a missing, rounded, or damaged set screw
• Helps maintain proper handle alignment and consistent door operation

• Unplug the appliance or switch off power before servicing
• Ensure the handle is fully seated on the studs before tightening
• Start the screw by hand to avoid cross-threading; then tighten until snug
• Do not overtighten to prevent stripping the screw or handle threads

M6-1.0 x 16mm mounting screw for bottom-mount refrigerators. Secures panels, brackets, and components. Replace when stripped, missing, or damaged.