Parts for Jenn-Air JDS8850CDW01: 01 - Cooktop Parts

This replacement screw secures appliance panels and components to restore proper fit and prevent rattling or movement. It's a direct-fit fastening part used where the original OEM screw is specified. What it does:

• Secures trim, access panels, or internal components to maintain structural fit
• Prevents vibration noise and loose parts by holding assemblies firmly
• Matches OEM fit and threading for correct engagement when used in original locations
• Intended for repairs that require the exact replacement fastener

• Disconnect power and unplug the appliance before starting any repair
• Use the correct screwdriver or bit to avoid stripping the head
• Tighten until snug; avoid over-tightening which can strip threads or crack plastic

This genuine replacement control knob restores secure, easy-to-use control of your appliance's settings. It provides a clear grip and pointer so selections are easy to read and change. What it does

• Replaces a cracked, stripped or missing control knob so the control shaft can be turned smoothly
• Restores a visible pointer for accurate temperature or cycle selection
• Helps prevent slipping or accidental changes by providing a firm grip
• Fits on a splined control shaft to engage the selector mechanism

• One control knob

• Remove the old knob by pulling it straight off the control shaft; push the replacement knob fully onto the shaft until seated
• If knob is tight, pull with a steady, even force or use a non-marring puller tool
• Disconnect power to the appliance before servicing if removal requires access behind the control panel
• Do not force onto an incompatible shaft; verify spline match before installation

This is a Whirlpool oven control board. The oven control board sits behind the main user interface assembly. This board works in direct conjunction with the buttons on the interface to control the vital functions of the oven, such as bake, broil, and self-cleaning. Telltale signs of a malfunctioning control board are smells of burning plastic coming from the interface and losing one or more oven functions. Immediately discontinue using the appliance if a shorted control board is suspected. Begin installation by unplugging the oven from the power source. Open the oven door and remove the screws beneath the control board assembly. On the sides of the control assembly, two tiny screws hold it in place. Remove these, and with a slight pull, the user interface should pop off. The control board is directly behind the main assembly and is held by either two tiny screws or clips that loosen with a flat head screwdriver. Remove the control board from the wiring harness and begin installing the new component.This product is sold individually and is sourced directly from the manufacturer as a genuine OEM part. This product is compatible with Whirlpool and Jenn Air appliances.