Parts for Kitchenaid KERS807SBL04: 01 - Cooktop Parts

This part has been discontinued and is no longer available

Secures your oven gasket in place for a tight seal and consistent cooking. Replace if gasket is loose or heat escapes. Confirm fit with your model number.

Hot surface

This fixed thermostat switches near 60C to control a heat-managed circuit—often the oven's cooling/blower fan. Replacing a failed unit restores proper fan cycling and helps protect the control area from excessive heat during and after cooking.

• Monitors temperature in the oven cabinet/control area and switches power based on heat level
• Cycles the cooling/blower fan on and off to manage cabinet temperature
• Helps safeguard electronic controls from heat buildup
• Failure may cause symptoms such as a fan that won't run, a fan that runs continuously, or an unusually hot control area

• Disconnect power at the breaker before servicing
• Access the thermostat per your model; it is typically mounted to a plenum or bracket near the oven cavity
• Move wires one at a time and mount the new thermostat flat against the surface for accurate sensing
• Restore power and verify the fan cycles during operation

Burner not heating evenly or taking too long to boil water? This surface heating element restores proper heat output. Moderate DIY repair.

Burner not heating or heating unevenly? This dual radiant surface element restores consistent heat to both rings. DIY-friendly, installs in 15 minutes.

This replacement screw secures appliance panels and components so they stay tight and aligned during use. Replacing a missing or damaged screw restores a solid fit and helps eliminate rattles, loose trim, or shifting parts.

• Fastens brackets, panels, trim, or components to the appliance chassis
• Helps correct loose or missing hardware after vibration or service
• Replaces stripped, rusted, or broken screws
• Can reduce rattling noises or misaligned parts caused by missing fasteners

• Disconnect power; for gas appliances, also shut off the gas supply
• Support the part being fastened; start threads by hand to avoid cross-threading
• Use the correct driver size; tighten snugly without overtightening
• Replace hardware with the exact part number to ensure proper fit

Color: White

Color: Black

Replacement tension spring for cooktop assemblies. Restores proper tension for moving components. Order when original is stretched, broken, or missing.

Size: 6-32 x 3/8 inch.

This is a black gasket that seals the gap between the range backsplash and the control panel or countertop area. It prevents moisture, grease, and food debris from getting behind the appliance. Replace this gasket if it is cracked, warped, or missing, which can allow spills to seep into areas that are difficult to clean or could damage internal components.