Craftsman Chipper Shredder Parts

Engine o-ring gasket seal prevents oil and fuel leaks. Replace when cracked, flattened, or leaking. Verify fit with your model number before ordering.

Secures hoses to the carburetor on outdoor power equipment engines. Replace if clamp is rusted, broken, or missing to prevent fuel or air leaks.

This is a genuine OEM clamp sourced directly from the manufacturer. It is used in various lawn and garden machines to connect hoses to fittings. It is used to connect piping to water pumps, exhaust pipes to exhaust manifolds, and other similar applications. This connection prevents fluids or air from leaking from the hose. Clamps may be spring or screw/band clamps. Spring clamps require no tools to install and remove; however, the size must be more accurate than when using screw/band clamps. Screw/band clamps are adjustable and can be tightened or loosened. Screw clamps should be inspected periodically to ensure tightness and that the clamps have not rusted.Hose clamps are installed approximately 1/4 inch below the end of the hose. If two clamps are used, there should be 1/4 inch between the two bands. When using a screw clamp, loosen the screw with a screwdriver just enough to fit the clamp over the hose. If using a spring clamp, squeeze the clamp and hold it open. Slide the clamp over the hose and then attach the hose and clamp to the fitting. Slide the clamp into place at the joint and tighten. Do not overtighten. This brass-colored clamp is a spring clamp made of metal; it is sold as an individual unit. This clamp is compatible with many different types of pipes made by various manufacturers.

Exhaust piping connects to the muffler system on small engines. Replace if cracked, corroded, or damaged to restore proper exhaust routing and function.

Threaded stud secures carburetor to intake manifold on lawn mower and outdoor power equipment engines. Replace if stripped, corroded, or missing.

Replace your chipper shredder's V-belt when you notice slipping, cracking, or reduced performance. Ensures proper power transfer to cutting blades. Verify fit using your model number before ordering.

Drive pulley half for snow blowers and snow throwers. Installs on the drive system. Replace if worn, cracked, or damaged to restore proper function.

Hex screw fastener for lawn tractors and outdoor power equipment. Secures components throughout the machine. Replace if stripped, overtightened, or missing.

Insulator plate for lawn tractors and riding mowers. Mounts between engine components to provide heat insulation and proper spacing. Replace if cracked or worn.

Replacement hydraulic hose for log splitters. Connects hydraulic components to power the splitting mechanism. Replace if cracked, leaking, or worn.

Protective hubcap for lawn mower wheels. Snaps onto wheel center to shield the axle and wheel frame from dirt and damage. Replace if cracked or missing.

Seals the fuel tank where the filter and neck meet on gas-powered equipment. Replace if worn, cracked, or missing to prevent fuel leaks and maintain seal.

Replacement discharge chute for chipper shredders. Directs wood chips and debris away from machine and operator. Replace if cracked, broken, or missing.