Parts for Whirlpool WRF736SDAB00: Dispenser Front Parts

Reduces contaminants in ice and water. Replace every 6 months for optimal filtration. Simple twist-out installation. Verify fit by model number.

Purifies circulating air in your refrigerator to reduce odors. Replace every 6 months for optimal freshness. Verify fit with your model number.

Refrigerator not cooling or display blank? This electronic control board manages temperature and system functions. Moderate difficulty repair requires basic tools.

Refrigerator not cooling or freezing food? A faulty main control board often causes temperature issues. This repair restores normal cooling functions.

This separator housing directs and isolates fluid flow inside the appliance to help the pump and drainage systems work correctly. Replacing a worn or cracked separator restores proper flow routing and helps reduce leaks and drainage problems. What it does:

• Channels water away from sensitive components to prevent cross-contamination or leaks
• Helps maintain correct pump suction and drainage performance
• Reduces the risk of water reaching electrical parts that could cause errors or shorts
• Can stop symptoms such as visible leaks, poor draining, or unusual pump noise

• One separator housing

• Disconnect power and water supply before starting any repair
• Inspect mating seals and clamps; replace if worn to ensure a watertight connection
• Handle plastic parts carefully to avoid cracks; do not overtighten clamps or fasteners

Decorative trim panel for refrigerator dispenser front. Replaces cracked, scratched, or discolored trim pieces. Restores clean appearance to dispenser.

Refrigerator trim piece for cosmetic finish and edge protection. Replace if cracked, chipped, broken, or missing to restore clean appearance.

Replace the dispenser trim on your refrigerator. This decorative cover frames the water and ice dispenser area. Order a new trim if cracked or damaged.

Ice won't dispense or freezer air leaks? This dispenser door opens and closes to control ice flow from the bin to the chute. Simple snap-in installation.

Ice not dispensing or melting in bin? This separator guides ice from maker to dispenser and controls airflow. Fixes cracked or warped ice doors.

Ice won't dispense or spills from chute? This dispenser door controls ice flow and seals the chute. Simple snap-in installation takes 10 minutes.

This is a small plastic drip tray that sits beneath the water or ice dispenser on the front of the refrigerator to catch spills and overflow. It helps keep the floor and exterior of the refrigerator clean during dispensing. Replace this tray if it is cracked, warped, discolored, or no longer fits securely in place.

Catches drips and spills beneath your refrigerator's ice/water dispenser. Replace if cracked, broken, or missing to protect your door and floor.

Illuminates your refrigerator's ice and water dispenser area. Replace if light is dim, flickering, or out. Confirm fit with your model number.

Secures panels, brackets, and internal components. 10-16 thread fastener for sheet metal and plastic mounting. Replace missing or stripped screws.