Gary S Lakeland , FL June 27, 2015 Appliance: Bosch GE010-010 Temp switch &a back assembly both were broke and needed replacing Ordered both parts from appliance parts pro. I recived them within 2.5 days and with instructions had everything fixed and working within 20 min. Love you guys, keep up the good work. Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Pliers, Screwdrivers
Leah P Riverside , CA December 08, 2014 Needed new starter switch back assembly and knobs I followed the video, watched it several times, everything fit. Did not need a repairman to come out. I did not need to pay out the extra big money for labor. Great! Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Joann H Syracuse , NY August 11, 2025 Appliance: General Electric Gas Dryer DBSR463GG7WW One of the plastic tabs that holds the dryers starter switch in place had sheared off We replaced the old control panel with a new control panel. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Carl F Daytona Beach , FL August 03, 2025 Broken panel Replaced panel Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Margi L Warner , NH April 03, 2023 Broken plastic retaining clip holding switch assembly. Replaced the Control Panel / Back Assembly. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Wesley G Snellville , GA July 16, 2020 The start switch was dead and the plastic plate assembly which held the switch was broken Ordered replacement parts and replaced same. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Terri E Selinsgrove , PA June 17, 2016 Timers cracked n back assembly broke Ordered new knobs n back assembly Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Michael M Greensboro , NC March 21, 2016 Start switch broken The problem was that the housing on the main panel for the start switch had broken and the switch was no longer stable. So for quite sometime now I have been rigging it in place however I could so we could start the drier. I finally got tired of that and started looking up the parts. A few days later I received everything in the mail and got it all fixed up. Good as new now! Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers