How to Troubleshoot & Replace Ge AP2621539 / WE1M461 O Ring

Went ahead and replaced the pulley as well the drum bearing sleeve and O ring, drum belt and the front drum bearing slides. Put the unit back together and she ran like a top! 

I replaced everything was very easy work's great now 

I replaced the slide bearings a few years back. A few months later the rear bearing started to go so I replaced that one. Bad idea. Replace these two at the same time. The wobbling from the rear bearing failure caused accelerated wear on the slide bearings. Without the money to fix it I ran it as it was. Another bad idea. The drum not only chewed through the slide bearings, but eventually the assembly as well. I replaced the whole assembly and rear bearing at one time a couple days ago. It was really not that hard, though it did take a full day due to a stripped screw that eventually had to be drilled out. Would’ve only taken about an hour without that issue and now it runs smooth and quiet. 

Selected and ordered parts from online drawings. Watched videos showing how to make repair. Replaced worn parts with new ones. Suggested improvement: Videos didn't show my model (I know there are many models, showing all is probably not possible). In case of Felt the video showed a Maytag dryer when my model was GE. In my case Felt had torn and dislodge from slot so I didn't know exactly how it should be installed. A simple picture of the installed Item would help. Also the parts list should give number of each item required. The bearing slides require 2 of each type, the drawing only shows one and the parts list doesn't say 2 required. Other sites did specify this. 

Now it works perfectly with your part and especially your videos help. Thanks a lot 

Replaced both rear and top bearings and also the belt. Dryer works great now. Fairly easy job to do. 

Replaced rear drum bearing and front drum support. Replaced belt since I was in there already. Parts came quick and fit perfect. 

I ordered a rear bushing kit, a new belt, and a new front slide and support assembly. I watched videos on Youtube, but quickly just reverted to my own intuition. It took me 2-3 hours to finish because I spent a lot of time labeling wires to prevent any issue with reinstallation, glueing tabs back on the control panel that the Youtube guy said to just leave hanging, and cleaning (and cleaning) lint out of everything. Plus, it was tight quarters. If I had to do it again, it would take about an hour. 

I took the dryer apart to see what was going on with the sound. I found several parts that were worn out so I ordered the parts from you guys and fixed it myself. I was very happy with the delivery service as everything ships super-fast so I did not have a long down time in fixing it. 

Took it apart and replaced with new parts.