How to Troubleshoot & Replace Lg AP4437239 / 4775ER2002A Door Hinge Assembly

Replaced it with a new one from your site. Super fast shipping and the part was right on. Thank you! 

Replaced bearings and seal. This job is not very hard, but is not for everyone. The hinge assembly and clamp assembly were for a different washing machine. 

I removed and replaced the door hinge. The tip of the day here is to have a heat gun. The hinge mounting screws are installed with some type of locktite. The screws were unable to be removed. I heated each screw for about 30 sec and then they busted loose with ease. I did the whole job I under an hour. I did the entire job from the front of the washer. 

Watched the online instruction video and repeated the same steps. 

With the new door hinge I purchased from you and your you tube video. 

Viewed the great repair video, the best I have ever seen. It was very detailed and accurate. Removed old parts and ordered Door Lock Switch and Door Hinge Assembly. Excellent communication and immediate quick shipment. Replaced parts. Functions perfectly again. 

Overall, this was a great success! Ordered the parts from ApplicanePartsPros (New Hinge assembly and a new outer door gasket clamp). I really only needed the hinge but ordered a new clamp incase the old one broke during disassembly, a $7 insurance policy. Parts arrived the next day and I followed videos for a successful fix! 

Replaced with new hinge. Very happy with product and will be using company for items in the future. Company is very helpful. We had to take door off of washer and replace old hinge. 

What held me up was I stripped one of the screws while taking it apart. I had to drill it out. The repair was pretty easy otherwise. 

Unplug machine.. Shut off water supply to machine. Remove top cover. Take picture of valve assembly for reference later. Disconnect water supply hoses to machine. Remove and replaced both fill valves. Moving on to the door hinge. This hinge can be replaced without removing front cover. I did it just to see if I could. One note of advise is do not use a drill driver to R & R the screws that hold the hinge to the machine. Mine snapped one of the heads off. There are still five left so door is plenty secure. After I replaced the door hinge I went on and removed front panel. The best advise I can give anyone is to find and watch one of the many helpful videos on YouTube. The door seal is the hardest part of this fix because of the many steps involved in removing the front cover. Use detergent to lube the areas of the door seal that go over the outer tub and the door panel. This is a must and be liberal with the detergent. Again watch videos pausing when necessary. While you are in the machine, clean whatever you can and also clean your pump filter at the lower left of the front panel. Reassemble machine, connect water supply hoses and turn the water back on. Check for leaks. Plug machine back into the wall outlet. I did a test run by running a normal cycle with an Affreash tablet just to help clean the inside of the tubs. All in all an easy fix just be patient..