How to Troubleshoot & Replace Wci AP6890261 / 134557200NH Control

Replaced main control board. The actual repair was easy, finding the correct part was the challenge. Part of the model number was missing so the very friendly, and helpful representative checked all the possibilities to insure the new control board was the right one. It arrived in two days using regular shipping and we had the dryer repaired in about 15 minutes. Very positive experience. We were sure the control board would correct the problem, however the part was returnable- an unheard of possibility with electrical parts. 

Replaced control board that was purchased from Appliance Parts Pros. It was an easy fix because I had investigated how to do the repair ahead of time and got familiar with all of the wiring and harnesses. 

Replaced the control board. I found out the fix by simply Googling the error code. Watching the short video of the repair convinced me that this was easy enough for me to do by myself. I took out the old control board before ordering the new one just to ensure that I was ordering the right one. (The part numbers didn't match up at all.) I needed my husband's assistance to pull the dryer away from the wall and to loosen a couple of the tight screws, but after that he let me have all of the fun. I did take pictures as I went along, just to be safe, and I reference them to ensure that I hadn't turned any of the wire connections around. It probably wasn't necessary, though, since with the exception of the red and black wires there's only one way to re-attach them. 

My new dryer never worked properly from first day of purchase HH Gregg would not cooperate. I bought another dryer. purchased new computer bored. here in two days, 15 min. to replace. works great! thanks for your help 

Part arrived within 2 days and was exactly what was needed. The repair was fast and now the dryer works like new again. 

Took the dryer apart to get to the control panel then ordered the part. When the part arrived, I reassembled the dryer. Was easier to fix than I thought it would be. 

Very easy fix for a DIY guy. Fixed the problen and we are back in the drying business. 

I bought a few sensors and replaced the control unit with the help of Appliance Parts Pros how to do videos. Fingers crossed but so far looks like everything's working. 

Googled the issue, found the part, replaced it. 

Replaced main control board. New exactly what it was. Kept coming up with code E-68. Heater & thermostat was fine.Ordered from appliancepartspros.com. Cheaper then eBay & Amazon had what I wanted in stock. Sent to me. Had it less than 2 days at my doorstep. Took front control panel off and installed new less then 10 minutes, and was fixed. If your not familiar with the front loader dryer unit. Can take longer but is pretty easy if you follow directions.