How to Troubleshoot & Replace Whirlpool AP6010406 / WP67004284 Facade (Blk)

I ordered the 'decal' which wasn't all that I needed so I ordered the full façade. Note that you need the 'decal' as well as the façade as it doesn't come with it. I removed power from the fridge as there is 120VAC on the panel. I then removed the ice tray by simply pulling it away from the fridge. Removed the two screws behind the ice tray then pulled the façade down and away from the fridge. I removed the one screw from the printed circuit board and removed it along with the two lower wires. I hooked up the two wires to the new façade and installed the printed circuit board which proved a little difficult as the last 'clip' was difficult to engage. Put the screw back in the printed circuit board and re-installed the façade. The decal was a bit of a pain to line up correctly as it is a pretty tight fight. I did my best to 'rest' the bottom of the decal on the lower ridge while also trying to do the same on the right side. This worked OK but it took a couple of tries to get the edges to line up correctly. 

Unscrewed 2 screws located under spill tray. Removed black unit. Disconnected 2 pink wires by pulling them down. Remove tiny screw on board. Firmly but gently pull off the board that contains the lights and electronics for the water dispenser and then did everything in reverse to attach my new unit. 

Replaced fountain panel and selection insert.