I followed the directions provided on your videos. It was a pretty straight forward job. I started with the Upper Door Hinge Bearing . . . thought I had ordered the correct piece, but the "wings" on the bearing were too wide to fit the bearing opening, so I put the old bearing back in, Putting tape on the door (per the video) to hold it in place was an excellent tip. Next, again following the directions provided on the video, I removed and replaced the two pieces that form the Lower Door Cam. When I finished, the door would "clunk" down when opened fully. Upon inspection, I noticed a slight gap between the two Cam pieces (I don't know if it was the door or the base of the replacement "hinge" Cam was slightly shorter), so I removed the "hinge" Cam, put a washer between both of the securing bolts and the underside of the Cam, and put it back in place. It worked like a charm. My wife was happy. Happy wife, happy life.