Mark H Tomball , TX December 18, 2021 Appliance: Amana Self Cleaning Slide-In Downdraft Gas Range ARTC7021C Amana Range Artc7021c / P1143814n C: The center loop of broiler element sagged about 30 degrees below the sides a recurring situation. How to replace Electric Range Broil Element. I watched the video, to refresh my memory, and I'm glad I did. The tip to use wire ties to prevent the element's wires from falling out the back of the oven is good. I recommend removing the oven door, for easier access. In an attempt to prevent this situation from happening again, I decided to drill a hole in the top of the oven cavity, to accommodate a third support.. This took the most time, and it required reusing one of the old hangers.(Note: One of the new hangers lacked the 45-degree bend required; so, I ended up reusing both old hangers The installation video shows that someone, at some time, addressed this issue of sagging, by adding transverse support braces to the element. My total time was about 30 minutes, mostly due to the drilling for the extra hanger. Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes