Ultimately the only fix was to replace the main control board. The stumbling block there is that there are nine (9) bundles of wires and connectors that go to the board, and the wiring harness is not rigid, nor cut exactly to length, so it's easy to get them mixed up unless you have the foresight to label every bundle before disconnecting them from the old board. Also, in addition to the (expected) loose front panel buttons and springs, once you get the old board unscrewed from the back of the front panel there are a bunch of loose, molded plastic light guides that conduct the light from the LEDs to the front panel so you can see what selections have been made. And the large cycle-selection knob is actually several pieces that have to go back into the new board so that the correct selection shows up. All I can say is be careful, move the pieces SLOWLY and GENTLY, and use gravity to your advantage instead of fighting it.