I took the inside plate off door. Removed old gasket. Broke styrofoam vent buffernbecause I grabbed it in the wrong place. Ordered both a gasket and vent buffer from your company. It came in 2 days as promised. I had to empty dishwasher of about 2-3 inches of water as with the door apart and knowing it would leak I had to shut off electric supply and hand empty machine first cup by cup and then towel by towel. (Towel method worked well). Then I took a blow dryers to the inside of dishwasher, to the floor and the inner door buffers as I didn't want any mud tor mold tonfork. I accidentally lost my balance while blow drying the buffers on the inner door and burnt a hole right on the smaller pad. I became McGyver and filled hole with heavy string and secured with electric tape as I was confident this was a sound buffer and was not vital to replace and attain usable function of dishwasher. After watching multiple You Tube videos, I then again took off old gasket to inner door and put in the new gasket. I replaced vent buffer. Remounted the inner door part. Note that the open/close lever handle needs to fit throufh hole of the bottom of front door before door parts will align. You also need to remember or in my case look up which size screws go where. Then I remounted front floor panels under door. Also need to remember or look up which size screws go where. Honestly the hardest parts were emptying machine of water and remounting floor panels as you needed to recall that larger too part mounts over smaller part touching the loot to get parts to align with screw holes. But I was pretty proud to fix on my own for < $80 rather than paying s technician to come out. I know I would have paid at least $150!for him to repair it or may have bought a new dishwasher. I then laundered all towels. Eventually when I have more I will replace electrical tape securing inner door buffer with duct tape.