Followed the video instructions for replacing the front bearing slides, found the Drum Support Bearing worn beyond reuse. Decided since it was going to be apart anyway I would replace the rear Drum Bearing (no visible reason), the belt (even though it wasn't broken or visibly worn) and the Trap duct Felt because i didn't want to get into again for a while, Having said that it really isn't a bad job, the dryer comes apart with just a few fasteners and its a pretty simple procedure. The time it takes to do the job is less than what is stated but took extra time in cleaning each part of lint & dirt buildup as I went, Oh, don't forget to put the belt on with the grooves toward the drum because if you don't the drum will not turn with a load in it and you'll spend an extra 10 minutes correcting your mistake! ;-)