Replaced the speed control unit with the part from AppliancePartsPros.com It was a direct replacement, the only difference being that the wire connections were slightly different. Just had to pay attention a bit closer and mark each slide on the connector as I took them off so I could be sure of getting them back in the right place on the new part. The new part was about 1/3 of the cost of buying a whole new mixer, but I do feel the vintage of our mixer is a bit better than the imported versions KitchenAid is now supplying. Make sure when ordering you match the model number of your mixer, there are a lot of variations that have been produced over the years.