Jim S Lake Havasu City , AZ December 22, 2016 Tab broken on my ice dispenser I installed the broken tab kit. The previous owners had removed the parts, so I had to rely on the repair kit instructions. The pictures were almost useless and some of the written instructions were vague. At least the instruction showed the order of installation. Put some tape around the outer bracket too keep the tools from scratching the finish as you pry it off. It is quite of force to pop the bracket off the freezer door and not break something. The first problem was it was impossible to know which tab to break off. I broke off both tabs with the holes in them. The last in vital to keep the hinge from working loose. The metal bracket was very difficult to install. On the right side of the bracket there is adhesive on 2 planes. The lower adhesive tends to stick to the back wall before it before it adheres to the top. As a result the bracket slopes down on the right and it made for a lot of fiddling to make for a lot of fiddling to get the ice door to close properly. Because of the thickness of the metal plate you will need to file the top of the paddle bracket to insure the tabs that open the ice door are below the lip of the ice chute. The paddle spring was a pain and I use tape to hold the screw for installation. You need a piece of string attached to the hinge spring(ice door) and threaded over the paddle in order get the spring to sit against the bracket. Insure the head of the hinge is on the same side as the last tab. Do-It-Yourself Rating: Repair Time Estimate: 2+ hours