It was a simple replacement. Used a wet/dry vac to get as much water out of the tub as I could. I unplugged the washer and took out the drain hose from the wall. I tipped the washer forward to access the bottom. (You may have to disconnect your water lines, mine were long enough I did not have to.) Propped it on the wall to keep it from falling. Removed sound damping material. Then used pliers to detach the two hoses connected to the pump. There were three 5/16" bolt head screws to undo. Unplugged the wires from it. That was it. Putting it back together is just the reverse. The two wires do not have a specific order to put back on, they can be plugged onto either terminal. Simple and easy!