Parts for Ge JGBP61WEW1WW: 03 - Door & Drawer Parts

Positions and supports oven door glass to maintain proper alignment. Replace if worn, cracked, or missing to prevent glass rattling and gaps.

Replacement oven rack for electric and gas ranges. Installs inside oven cavity. Needed when original rack is missing, damaged, or warped from use.

Slotted grid that rests over the broiler pan to support food during broiling. Replace if cracked, warped, worn, or missing to restore proper function.

Replacement drawer panel that restores the front trim of your range drawer. Installs as the external front surface to replace a damaged, dented, or worn panel.

This metal grip allows you to safely pull out the broiler drawer for loading and unloading food. Located on the front of the broiler drawer beneath the oven, replace it if the handle is loose, broken, or becomes too hot to touch during use.

Includes 12 washers.

Includes 12 washers.

Door liner weld assembly for electric ranges. Replaces cracked, damaged, or broken door liner frames. Structural component that secures inner door panel.

Seals the gap between oven door and body to retain heat during cooking. Replace if cracked, worn, or heat escapes. Verify fit with your model number.

Includes 12 screws.

Side

Insulation strip that installs along the bottom of your electric range door. Replace if torn, compressed, missing, or damaged to restore proper fit.

Oven door glass window pack for viewing food while cooking. Replaces cracked, shattered, or broken glass. Installs inside the oven door frame assembly.

Inner welded panel assembly for range control/backguard structure. Restores secure fit and alignment. Replace if bent, cracked, or damaged to stop rattling.

Replacement drawer glide for range bottom drawer. Needed when glide is broken, cracked, or snapped, causing drawer to fall, scrape floor, or not slide.

Secures the lower storage drawer assembly to your range cabinet. Replace this stamped metal bracket if cracked, bent, or missing to restore alignment.

Replacement mounting screw for range panels, brackets, and trim. Restores secure fit when original fastener is missing, stripped, or damaged.

Replacement terminal endcap for electric ranges. Covers exposed connector ends to restore a finished look and prevent accidental contact. Needed when cracked or missing.

Replace a cracked, warped, or missing heat deflector shield on your range. This protective guard installs near heating elements to direct heat properly.

This part has been discontinued and is no longer available.

Finishing piece that fits on either end of your range door handle. Replace if cracked, broken, or missing to restore appearance and secure the handle.