Parts for Frigidaire FED355CCSG: 05 - Door Parts

Length: Approx. 82 1/2"

This refrigerator/freezer door gasket creates an airtight seal around the door to help maintain proper temperature and reduce energy use. It replaces a worn or damaged seal to improve cooling and reduce frost buildup. What it does:

• Seals the cabinet to keep cold air in and warm air out
• Helps prevent excess frost and moisture inside the compartment
• Reduces compressor run-time caused by air leaks
• Restores proper door alignment and consistent cooling

• Disconnect power and remove food from affected compartment before starting
• Remove the old gasket and thoroughly clean and dry the gasket channel before installing
• Press the new gasket into the channel evenly, starting at a corner and working around the door
• Check the seal by closing the door; adjust or reseat as needed for a uniform contact

This white handle trim restores the finished look and grip area on compatible appliance doors. It replaces a cracked, faded, or missing trim piece to improve appearance and create a clean edge around the handle area. What it does

• Covers and protects the handle mounting area while providing a smooth, finished appearance
• Replaces trim that is cracked, warped, discolored, or otherwise damaged
• Helps prevent sharp edges and improves the grip area for normal door use
• Matches factory styling so the door looks original and uniform

• One white handle trim piece as shown

• Basic removal of the old trim and reattachment of the new trim; fasteners and clips are present before installation
• Use proper tools to avoid scratching surrounding surfaces; support the door or panel if needed
• Disconnect power or follow appliance-specific safety steps when working near electrical components
• If fasteners or clips are missing or damaged, replace them before completing installation

This is a replacement screw used to secure appliance panels and components. It restores proper fastening so panels, trim, or assemblies stay tight and reduce vibration or rattling. What it does

• Fastens panels, brackets, or trim to the appliance chassis
• Helps stop loose or vibrating panels and trim pieces
• Restores proper alignment where a missing or stripped screw causes gaps or movement
• Use when the original screw is missing, damaged, or corroded

• One replacement screw as shown

• Disconnect power to the appliance before starting any repair
• Use the correct screwdriver or bit to avoid stripping the screw head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Keep removed screws in a safe place; this screw matches the original before installation