Parts for Frigidaire FRT18PNFD2: 02 - Door Parts

The Refrigerator Door Gasket is an OEM part for Frigidaire refrigerators. It provides a tight seal around the refrigerator door, ensuring that cold air stays inside and warm air stays out, maintaining optimal temperatures for food preservation. The gasket measures approximately 29-1/2" wide x 44" long. 

Causes of a bad door gasket can include wear and tear over time, damage from frequent opening and closing of the door, or improper cleaning that leads to cracks or tears. A compromised gasket can lead to energy inefficiency and affect the refrigerator's performance.

Symptoms of a bad door gasket include:

• Noticeable gaps between the door and the refrigerator
• Increased energy consumption
• Frost buildup around the door seal
• Difficulty in closing the refrigerator door properly

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

Rack is approximately 25 3/4" long. It may have to be cut for certain models.

Color: White (Used on RH side)

Color: white. (Used on LH side)

Color: white. (Used on LH & RH side)

Rack is approximately 25 3/4" long. It may have to be cut for certain models.

This part has been discontinued and is no longer available.

The Screw is an OEM replacement part for Frigidaire refrigerators. This small but essential component is used to secure various parts of the appliance, such as panels, brackets, or internal fixtures, ensuring the refrigerator's structural integrity and proper operation.

Over time, screws may become loose, stripped, or corroded due to regular use, environmental factors, or maintenance work. A damaged or missing screw can lead to misaligned parts or reduced stability of the appliance.

Symptoms of a bad or missing screw include:

• Loose or wobbly components within the refrigerator
• Panels or fixtures coming apart or misaligned
• Difficulty securing parts during maintenance or repair
• Rattling or unusual noises during operation

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

Stick on

Snap in

This replacement screw secures appliance components so brackets, shelves, trim, or panels stay firmly in place. Install a new screw when the original is missing, stripped, or corroded to restore a tight, rattle-free fit.

• Fastens brackets, panels, trim, or covers to the cabinet or liner
• Helps maintain alignment and reduce vibration and noise
• Direct replacement for a missing, rusted, or stripped fastener
• Use wherever your model's parts diagram specifies this screw

• Disconnect power before servicing; shut off water if working near water lines
• Match thread and length to the original location as shown in your model's parts diagram
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening (especially into plastic)
• Retain and transfer any original spacers or clips used with this fastener

Size: Approximate 2.5 inches thick, 33 inches wide and 70 inches long.