Parts for Frigidaire GLEB30S8AQA: 07 - Door Parts

Length: Approx. 82 1/2"

This spacer positions and separates mounting components to maintain proper clearance and alignment, helping panels and hardware fit securely. It prevents rubbing and keeps assemblies stable for quieter, correct operation. What it does:

• Maintains required gap between panels or mounting surfaces to prevent binding or interference
• Keeps screws, brackets, and panels aligned for a proper fit
• Reduces vibration and rattling caused by loose or misaligned parts
• Helps restore proper clearance when replacing worn or missing spacers

• Disconnect power before accessing internal panels or fasteners
• Replace like-for-like; spacer location and orientation during removal
• Handle surrounding trim and panels carefully to avoid damage
• If fasteners are damaged or stripped, replace them rather than over-tightening

This handle spacer fills the gap behind a refrigerator or freezer door handle to ensure correct spacing and a finished look. It helps restore handle alignment and prevents rubbing or looseness for a neater, more secure fit. What it does:

• Positions the handle at the correct distance from the door for proper clearance
• Prevents the handle from rubbing against the door surface or seal
• Restores proper handle alignment to reduce looseness or wobble
• Matches bisque finish for a consistent appearance

• One handle spacer

• Basic hand tools required; follow the appliance's service instructions for handle removal/installation
• Keep original screws and hardware; replace only the spacer unless other hardware is damaged
• Do not overtighten fasteners—snug is sufficient to avoid cracking the spacer

This adhesive seal tape is a replacement sealing strip used to restore a tight seal on appliance doors and panels, helping reduce air leaks and improve temperature control. It's a simple repair for worn or damaged seal edges. What it does:

• Provides a flexible, adhesive sealing surface to close gaps between door/panel and cabinet
• Helps reduce air or moisture leakage that can cause temperature loss or inefficient operation
• Restores worn or deteriorated sealing surfaces without replacing the entire gasket
• Compatible with applications where a narrow adhesive sealing strip is required

• Clean and dry the mounting surface thoroughly before applying for best adhesion
• Measure and trim the tape to fit; press firmly along the full length to ensure contact
• Allow adhesive to set per ambient conditions before closing the door or returning to service

Specs: 8 - 18 x 0.500

This is a #8 screw, 0.500 inch long, used to secure panels and components in appliances. It provides a correct-fit fastener for repairs where the original #8 x 1/2" screw was required, restoring proper assembly and stability. What it does:

• Fastens trim, panels, brackets and small components where a #8 x 1/2" screw is specified
• Holds parts securely to prevent rattling, gaps or loose panels
• Replaces worn, stripped or missing screws to restore proper fit
• Appropriate for common interior and exterior appliance mounting points

• Use the correct screwdriver (typically Phillips) and avoid over-tightening to prevent strip or damage
• Disconnect power and follow appliance manufacturer safety instructions when accessing internal parts