Parts for Frigidaire RT19F8WT3E: 02 - Door Parts

This part has been discontinued by the manufacturer and is no longer available.

This wheat-colored electrical plug restores a secure connection in the appliance wiring harness, helping ensure reliable power delivery to components and reducing intermittent operation or loss of function. What it does:

• Provides a secure, color-coded connection point for wiring harness terminals.
• Holds and insulates mating terminals to prevent shorts and corrosion.
• Maintains continuity to the associated component so it runs reliably.
• Common symptom: component or circuit works intermittently or not at all when the plug or its terminals are loose or damaged.

• Always disconnect power to the appliance before inspecting or replacing electrical parts.
• Match plug orientation and fully seat the connector until it clicks; do not force.
• Inspect wiring and terminals for damage; replace any frayed wires or corroded terminals before installing.
• After installation, restore power and verify the affected component operates normally.

This hinge plug fits coffee maker hinge assemblies to cover and protect the pivot area, helping keep the hinge moving smoothly and preventing debris buildup. Simple replacement for worn or missing hinge covers. What it does:

• Covers the hinge pivot on the coffee maker to protect against dirt and spills
• Helps maintain proper hinge alignment and smooth door/lid movement
• Reduces wear on the hinge by blocking debris and moisture
• Commonly replaced when the original plug is cracked, broken, or missing

• Designed for a snap-in or press-fit installation; replace when hinge is exposed or damaged
• Disconnect power and ensure the appliance is cool before servicing near the brewing area
• Use care not to force the plug; align with the hinge pivot and press until fully seated
• If other hinge components are damaged, inspect and replace them as needed for proper function

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

Color: White

This white refrigerator door panel replaces a scratched, dented, or discolored outer door surface to restore appearance and protect internal components. Fits where the outer decorative or service panel is damaged or removed. What it does:

• Replaces the outer door surface to restore the unit's cosmetic finish and protect underlying parts.
• Covers and protects the door frame, insulation, and inner liner from damage.
• Helps eliminate visible dents, deep scratches, chips, or yellowing on the exterior door.
• Restores a uniform exterior appearance after panel removal during service.

• Intended for the left or right outer door (verify orientation with your model diagram before ordering).
• Remove power and empty the door before removing the old panel; handle panel edges carefully to avoid cuts.
• Reuse existing fasteners and trim unless damaged; replacement hardware may be required.

The Refrigerator Door Gasket is an OEM part for Frigidaire refrigerators. This gasket forms a seal around the refrigerator door, ensuring that cold air stays inside and warm air remains outside, maintaining the appliance's efficiency and keeping food fresh.The gasket measures approximately 44.6" X 30.69"

Causes of a bad door gasket can include regular wear and tear, mold or mildew buildup, and physical damage from repeated opening and closing of the door. 

Symptoms of a bad refrigerator door gasket include:

• Warm air entering the refrigerator, causing it to run more frequently
• Condensation or frost buildup inside the refrigerator
• Difficulty keeping the door closed
• Visible cracks, tears, or deformation in the gasket

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

Size: Approximate 2.5 inches thick, 33 inches wide and 70 inches long.