Parts for Ge L2B115GEL2: 01 - Section1 Parts

This end cap secures the refrigerator light housing and helps keep the lens and bulb in place for reliable interior lighting. Replaces a worn or broken end cap to restore a snug fit and prevent rattling or light misalignment. What it does

• Secures the end of the refrigerator light housing and helps hold the lens and bulb assembly in position.
• Common symptom: cracked or broken end cap allowing the lens or bulb to shift, rattle, or fall.
• Restores a tight fit at the light housing end so the interior light operates and stays properly aligned.
• Fits into the existing light housing and works with the factory lens and bulb.

• One end cap for the light housing.

• High-level replacement: part typically snaps or screws into the light housing; keep power off to the appliance before starting.
• Disconnect power or unplug the appliance before attempting service to avoid electrical shock.
• Handle the lens and bulb carefully; avoid forcing the cap to prevent cracking surrounding plastic.
• Use manufacturer screws or clips removed from the old cap if the new cap does not include fasteners.

Package of 12 washers for ranges and ovens. Replaces missing, worn, or damaged washers used in various mounting and assembly points throughout your appliance.

Plastic spacer that fits between range door panels to maintain proper spacing. Replace if cracked, broken, or missing to restore door alignment.

Replacement washer for oven door handles. Installs between handle and door surface. Order when original is cracked, worn, or missing to secure handle.

This spark module controls the ignition sparks for a gas range or cooktop, letting the burner surface and oven ignite reliably. Replaces a failed ignition control to restore sparking at the burner electrodes. What it does

• Sends timed spark pulses to burner electrodes so gas ignites when a burner or oven is turned on
• Replaces a failed or intermittent ignition source that causes clicking without ignition
• Commonly used when one or more burners won't light or spark consistently
• Works with electrode wires and ignition switches to coordinate burner ignition

• Spark module (1)

• Disconnect power and shut off the gas supply before starting work
• Label or photograph existing wire connections to ensure correct reconnection
• Handle the module and wiring harness carefully; avoid pulling on wires or connectors

ST10-16 X 7/16"

Replacement mounting screw secures panels, brackets, and components in place. Needed when original fasteners are missing, stripped, or damaged.

Nickel