Parts for Ge PCR06BATJSS: Door Parts

The Magnetic Gasket is an OEM part for GE refrigerators. This part is a flexible seal that runs along the edge of the refrigerator door, ensuring a tight closure. The magnetic gasket helps to maintain the internal temperature by preventing warm air from entering and cold air from escaping, thus enhancing energy efficiency and preserving food quality.

Causes of a bad magnetic gasket can include wear and tear over time, physical damage from frequent door openings and closings, or loss of magnetism which can weaken the seal.

Symptoms of a bad magnetic gasket include:

• The refrigerator door not closing properly
• Warm air leaking into the refrigerator
• Increased energy consumption
• Frost buildup inside the refrigerator
• Visible cracks or deformities in the gasket

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

A small adhesive MG logo emblem that restores the original appearance of your appliance. This peel-and-stick badge replaces a worn, faded or missing logo to keep the exterior looking factory-fresh. What it does:

• Cosmetic replacement for a missing, scratched or faded MG emblem
• Adheres to control panels, doors or trim where the original badge was located
• Restores brand identification and a finished appearance to the appliance
• Simple adhesive design avoids the need for fasteners or tools

• Clean and dry the mounting surface before applying to ensure good adhesion
• Peel backing and press firmly in place, aligning carefully before contact
• Avoid repositioning once attached; removal may damage the emblem or finish
• For safety, disconnect power before working near electrical controls or panels

This hinge fill plug covers and seals the fridge/freezer door hinge opening to keep the hinge area tidy and reduce dirt and moisture entry. It restores the finished look and helps protect hinge hardware from debris. What it does:

• Covers the hinge opening or bolt for a clean appearance
• Helps keep dirt, dust and moisture out of the hinge cavity
• Protects hinge hardware from contamination that can affect movement
• Useful when a factory hinge cap is missing or damaged

• Typically snaps or presses into place; minimal tooling required.
• Support the door if removing hinge hardware; follow the appliance manufacturer's safety instructions.
• Disconnect power before working on electrical components nearby.
• If the old plug is brittle or stuck, gently pry with a plastic tool to avoid cosmetic damage.