Parts for Kenmore 253.58682891 (25358682891, 253 58682891): Door Parts

Refrigerator freezer door gasket seals cold air inside. Replace if worn, torn, or allowing air leaks. Confirm fit with your model number before ordering.

Replacement end cap support for refrigerator door racks. Secures and stabilizes door bins. Needed when original support is cracked, broken, or missing.

Endcap support bar for refrigerator door racks. Secures and stabilizes door bins. Replace if cracked, broken, or missing to restore proper door storage.

Refrigerator door bar with end caps installs on the inner door to hold bottles and condiments. Replace if cracked, broken, or missing end caps.

Cut to fit design.

Replacement door handle for your freezer. Installs on the exterior door to provide a secure grip for opening and closing. Replace if cracked, broken, or missing.

Phillips truss head screw secures the door stop assembly on your refrigerator. Replace if missing, stripped, or damaged during door maintenance or repair.

Replacement mounting screw for refrigerator panels, handles, brackets, and internal fixtures. Order when original screws are stripped, lost, or damaged.

Stick on

Wiring harness that connects the dispenser controls in your refrigerator freezer door. Replace if wires are damaged, frayed, or connections are loose.

Pan head screw for refrigerator assembly and panel mounting. Replace missing, stripped, or loose screws to secure components and maintain structural integrity.

Plastic mounting block that anchors the refrigerator door handle assembly. Replace if cracked, broken, or causing a loose handle from repeated use.

Specs: 10-16 X 0.500

Replace a loose or missing extension lock washer causing rattling noises or unstable component mounting. Simple DIY fix in under 15 minutes.

Replacement owners manual for your refrigerator. Provides operating instructions, maintenance guidelines, and troubleshooting information for your model.

Size: Approximate 2.5 inches thick, 33 inches wide and 70 inches long.

Size: 60 inches x 1 1/4 inch x 1/32 inch. Used to hold the ice and water dispenser cover in place.

#10 OD, steel

Hex head screw for securing panels and components in freezers, refrigerators, washers, and dryers. Replace if missing, stripped, or corroded.

Secures cantilever shelves to prevent shifting or slipping. Replace if cracked, broken, or missing to restore stable shelf support. Confirm fit with model.

This filter wrench is a ring-style tool used to loosen or tighten a refrigerator's water filter housing or canister. It provides extra leverage to free a stuck filter cup and helps ensure an even, secure reinstallation.

• Provides leverage to loosen a stuck water filter housing/cup
• Assists with secure, even tightening during reinstallation
• Useful when the housing is difficult to turn by hand
• Helpful in tight spaces where hand access is limited

• Turn off the water supply and dispense water to relieve pressure
• Position the wrench around the filter housing/cup; turn counterclockwise to loosen
• After replacing the filter, tighten the housing until snug—do not overtighten
• Restore water supply and check for leaks