Parts for Kenmore 253.60722014 (25360722014, 253 60722014): Door Parts

This is the rubber door gasket that seals the freezer door to the cabinet, preventing warm air from entering and cold air from escaping. It attaches along the perimeter of the door and creates an airtight seal when the door is closed. Replace this gasket if you notice frost buildup inside the freezer, the door doesn't seal tightly, the compressor runs constantly, or the gasket is cracked, torn, or warped.

Interior freezer door panel that provides structural backing and a clean surface. Replace if cracked, dented, warped, or damaged to restore appearance.

Nameplate label for freezers and refrigerators. Mounts on exterior cabinet to display model information. Replace if faded, peeling, or missing.

Replacement door handle for your freezer. Installs on the exterior door to provide a secure grip for opening and closing. Replace if cracked, broken, or missing.

Replacement screw for securing panels, brackets, and internal components in freezers and refrigerators. Use to replace missing or stripped hardware.

Bearing insert for freezer door hinges. Replaces worn or damaged bearings that cause stiff door operation or poor alignment. Installs in hinge bracket.

Replace your worn freezer door gasket to restore an airtight seal, prevent cold air loss, and reduce frost buildup. Confirm fit by model number.

Secures interior trim and panels in refrigerators and freezers. Replace when trim becomes loose or rattles. Confirm fit with your model number.

This door rack mounts to the inside of the refrigerator or freezer door to hold small items securely. Replace a cracked or missing rack to restore door storage and prevent items from falling when the door opens and closes.

• Provides additional storage on the inner door for jars, condiments, and small items
• Helps keep contents organized and stable during door movement
• Common symptoms: broken or missing rack, items falling from the door, reduced storage space
• Restores original fit and function when the existing rack is damaged

• Unplug the appliance before servicing
• Remove items from the affected door area
• Lift or release the old rack from the end supports/slots; seat the new rack fully into the same supports
• Confirm the rack is secure before reloading and avoid overloading to prevent damage

Plastic plug insert for freezer door base. Covers screw holes or mounting points. Replace if cracked, missing, or worn to restore a clean appearance.

Plastic mounting block that anchors the refrigerator door handle assembly. Replace if cracked, broken, or causing a loose handle from repeated use.

Specs: 10-16 X 0.500

Replacement screw that secures brackets, shelves, trim, panels, and covers inside your appliance. Install when the original is missing, stripped, or corroded.

Mounting nut anchor insert for freezers. Provides a secure threaded point in thin sheet metal for fastening panels or components. Replaces missing insert.