Parts for Kenmore 790.42519313 (79042519313, 790 42519313): Door Parts

Oven won't maintain temperature or exterior gets too hot? This insulation blanket contains heat and protects nearby components. Moderate DIY repair.

Inner door glass panel for range and wall oven doors. Replace if cracked, shattered, or slipped out of position. Installs between outer glass and oven cavity.

Replace cracked, shattered, or discolored oven door glass. This clear viewing panel installs in the oven door and restores proper insulation and visibility.

Replacement glass spacer for ovens and ranges. Positions and cushions glass components to prevent rattling, chipping, or contact damage. Restores alignment.

Mounting spacer positions and supports range components for proper alignment. Replace if worn, cracked, or missing to restore correct panel fit.

Replacement handle for electric ranges and wall ovens. Mounts to the oven door for easy opening and closing. Order now if your original is broken or cracked.

Secures and routes wiring cables inside your range or oven. Replace this retainer bracket if it's cracked, broken, or missing to properly support cables.

Fastens panels, brackets, and covers inside your range or oven. Replace this screw if missing, stripped, or rusted to secure components properly.

Spacer that maintains proper gap between components in your range or oven assembly. Replace if missing, worn, or damaged to restore correct fit and alignment.

This is a replacement screw used to secure appliance panels and components. It restores proper fastening so panels, trim, or assemblies stay tight and reduce vibration or rattling. What it does

• Fastens panels, brackets, or trim to the appliance chassis
• Helps stop loose or vibrating panels and trim pieces
• Restores proper alignment where a missing or stripped screw causes gaps or movement
• Use when the original screw is missing, damaged, or corroded

• One replacement screw as shown

• Disconnect power to the appliance before starting any repair
• Use the correct screwdriver or bit to avoid stripping the screw head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Keep removed screws in a safe place; this screw matches the original before installation