Parts for Kitchenaid KHHC2090SSS3: 02 - Door Parts

An electronic control board that serves as the appliance's central command module. It manages cycle timing and powers key components, helping your unit start, run, and complete cycles correctly when the original board fails.

• Interprets inputs from sensors and user controls to execute programmed operations
• Switches relays/triacs to deliver power to motors, pumps, valves, heaters, or fans as required
• Monitors feedback to advance timing and protect components from faults
• Failure may present as: won't start, unresponsive controls/display, stops mid-cycle, erratic operation, or error codes/beeping

• Disconnect power at the breaker before servicing; verify no voltage present
• Use ESD precautions; handle the board by its edges and avoid touching components
• Photograph/label wiring; move connectors to the new board one at a time until fully seated
• On some models, run any required diagnostics or calibration per the unit's tech sheet after installation

The Spacer is an OEM part for Whirlpool microwaves. It is used to create a specific distance between components, ensuring proper alignment and function within the microwave. This spacer is critical for maintaining the correct positioning of parts during operation.

You should replace this spacer if it becomes damaged or worn out. Causes of a bad spacer can include mechanical stress, heat exposure, or accidental damage during repairs or maintenance. A compromised spacer can lead to misalignment of microwave components, affecting overall performance.

Symptoms of a bad spacer include:

• Misalignment of internal parts
• Unusual noises during microwave operation
• Improper functioning of the microwave components

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This factory fastener replaces a worn or missing screw to securely hold appliance components in place. Use it to restore a tight, rattle-free fit so panels, brackets, or assemblies stay properly aligned during everyday use.

• Secures panels, brackets, or internal components
• Helps correct loose, rattling, or misaligned parts
• Useful when a screw is stripped, corroded, or missing
• Maintains proper fit and stability after service

• Disconnect power and shut off water supply before service
• Match the original screw location and orientation; replace like-for-like
• Start threads by hand to avoid cross-threading; do not overtighten
• If threads are damaged, repair or replace the receiving clip/insert