Parts for Electrolux FGGF304DPFA: 06 - Doors Parts

Cosmetic trim piece for gas range. Replaces cracked, chipped, or missing trim. Covers gaps and provides finished appearance around range components.

This trim piece is a factory-style decorative/replacement trim for your refrigerator door that restores a finished appearance and protects the door edge from wear. It matches OEM fit and finish for a clean, finished look. What it does:

• Covers and protects the exposed edge of the refrigerator door for a finished appearance
• Hides gaps between door components and the cabinet for improved aesthetics
• Replaces cracked, chipped or worn trim that detracts from the appliance appearance
• Helps maintain an even seal line by keeping trim aligned and intact

• One refrigerator door trim piece

• High-level replacement — typically held by clips or screws; remove door panels or inner liners only if required by your model
• Power off and unplug the appliance before beginning any repair that requires panel removal
• Use care to avoid scratching adjacent surfaces during installation; retain all fasteners

Oven won't maintain temperature or exterior gets too hot? This insulation blanket contains heat and protects nearby components. Moderate DIY repair.

Heat-resistant insulation that wraps the oven cavity to contain heat. Replace if worn, damaged, or missing to improve heat retention and efficiency.

Replacement mounting screw that secures panels, trim, and components in ranges and ovens. Needed when original screws are lost, stripped, or damaged.

This spacer positions and cushions refrigerator components to prevent contact and reduce vibration, helping panels and assemblies align correctly for reliable operation. Lightweight and simple to install, it restores proper fit where the original spacer is damaged or missing. What it does:

• Keeps panels, trim, or internal components spaced correctly to maintain alignment
• Absorbs minor vibration and prevents metal-to-metal contact that can cause noise
• Helps preserve seals and door alignment by maintaining correct component clearance
• Common symptom: loose trim, rubbing panels, rattling, or visible gap where a spacer is missing

• One spacer

• Disconnect power to the appliance before beginning any work
• Remove adjacent panels or trim as needed to access the spacer; retain fasteners for reassembly
• Inspect surrounding clips or mounting points and replace any damaged hardware

Replacement glass spacer for ovens and ranges. Positions and cushions glass components to prevent rattling, chipping, or contact damage. Restores alignment.

Replace your gas range oven door hinge if it's cracked, broken, or worn. This hinge attaches the oven door to the range body for smooth opening and closing.

This is a door hinge designed for the lower oven door on a range. It allows the oven door to open and close smoothly and holds it securely in place when shut to maintain proper heat retention. Replace this hinge if the oven door is sagging, not closing flush, difficult to open or close, or if the existing hinge is visibly bent or broken.

Replacement handle for range oven doors. Installs on the front door panel for gripping and opening. Needed when original handle is cracked or broken.

Fastens panels, brackets, and covers inside your range or oven. Replace this screw if missing, stripped, or rusted to secure components properly.

Chrome screw secures handles, door trim, and internal components in ranges and ovens. Replace if lost during cleaning, stripped, or missing after moves.

Replacement screw secures panels, trim, and internal components in your appliance. Needed when original fastener is missing, stripped, or damaged.