Parts for Ge ZIP360NPB: Doors Parts

This bracket and bumper assembly secures and cushions the refrigerator door hinge to keep the door aligned and closing smoothly. It replaces worn or broken hinge hardware to restore proper door fit and reduce closing noise. What it does:

• Supports the door hinge mounting and keeps the hinge correctly positioned
• Provides a rubber bumper surface to prevent metal-on-metal contact and absorb impact
• Helps maintain door alignment and an even gap for a proper seal
• Commonly used when the door hangs unevenly, binds, or makes noise while closing

• One bracket and bumper assembly

• Disconnect power to the appliance before starting any work
• Support the door while removing hinge fasteners to prevent the door from shifting or falling
• Use basic hand tools; remove any trim or shelves only if they obstruct access
• After installation, check door alignment and adjust as needed

Size: 10-32 GXTT FLP.595 S

Door bushing for refrigerators. Installs on door hinges to reduce friction and ensure smooth opening. Replace if cracked, worn, or missing.

Seals your refrigerator door to maintain proper temperature and prevent cold air loss. Replace if worn, cracked, or loose to improve efficiency.

Bottom door hinge for refrigerators and freezers. Secures and supports the lower door edge. Replace if cracked, bent, or worn to restore proper alignment.

Replacement top hinge assembly for side-by-side refrigerator freezer doors. Needed when the hinge is cracked, broken, or worn causing door misalignment.

Top right door hinge assembly for refrigerators and freezers. Replaces damaged, worn, or broken hinges that cause door misalignment or sagging.

Seals the fresh food compartment to prevent cool air loss and maintain proper temperature. Replace if torn, cracked, or no longer sealing tightly.

Seals freezer drawer to prevent cold air loss and frost buildup. Replace if torn, cracked, or causing ice formation. Verify fit with your model number.

This top left freezer door trim replaces the damaged or worn decorative trim on the upper edge of the freezer door, restoring a clean finished look and proper edge fit. Ideal for maintaining door appearance and seal alignment. What it does

• Covers and protects the top outer edge of the freezer door from dings and wear.
• Helps maintain correct door alignment and keeps the door edge flush with the cabinet.
• Restores the appliance's finished appearance after damage or cosmetic wear.
• Compatible with left-hand freezer door installations (top position).

• Disconnect power to the appliance before attempting any repair.
• Remove door hardware and existing trim carefully to avoid scratching the door finish.
• Reinstall trim using factory screws/clips; retain original fasteners unless replacements are specified.
• If the door doesn't close properly after install, recheck alignment and fastener tightness.

Replacement freezer door handle trim covers fastening hardware for a clean, finished look. Restores appearance when original is cracked, faded, or broken.

Anti-tip hardware assembly secures your refrigerator to the floor or wall. Replacement needed if brackets are broken, missing, or worn from installation.