Parts for Electrolux E30WD75ESS1: 05 - Drawer Parts

10-24 x 1/2 inch machine screw that secures temperature probe and thermistor brackets to cooktop, oven, and range chassis. Replace if missing or stripped.

This is a stainless steel door handle designed for a wall oven or range oven door. It mounts to the outer door panel and provides a grip for opening and closing the oven. Replace this handle if it is cracked, bent, discolored, or if the mounting studs have broken off.

This metal rack fits inside the warming drawer beneath the oven, providing a flat surface to hold plates, dishes, or cooked food at a warm serving temperature. It slides in and out of the drawer on built-in guides. Replace it if the rack is bent, warped, rusted, or missing, which can prevent proper food placement and even heat distribution in the warming drawer.

10-24 x 1/2 inch machine screw that secures temperature probe and thermistor brackets to cooktop, oven, and range chassis. Replace if missing or stripped.

This rivet is a small metal fastener used to secure panels, trim, and small appliance components so assemblies stay stable and aligned. Replacing a damaged or missing rivet restores proper fit and reduces noise from loose parts. What it does:

• Secures sheet metal panels, trim pieces, or small brackets in place
• Keeps components aligned and prevents shifting or sagging
• Replacing worn or broken rivets can stop rattling or loose-feeling panels
• Use when a rivet is missing, bent, sheared, or otherwise damaged

• Typically installed with a pop-rivet tool or pressed into place depending on application
• Remove damaged rivets by drilling out the center or cutting them free before installing the replacement
• Wear eye protection and follow tool manufacturer safety instructions

10-24 x 1/2 inch machine screw that secures temperature probe and thermistor brackets to cooktop, oven, and range chassis. Replace if missing or stripped.

This is the exterior handle mounted on the oven door, used to open and close the door during cooking. It attaches to the door with mounting brackets or screws. Replace this handle if it is cracked, broken, loose, or if the mounting points have become damaged, making it difficult to safely open the oven door.

This replacement screw secures appliance panels, brackets, and internal components. It restores a tight, rattle-free fit and proper alignment when an original fastener is missing, stripped, or corroded.

• Fastens metal or plastic parts to the cabinet/frame
• Helps maintain alignment and reduce vibration or rattling
• Direct replacement for lost, damaged, or rusted hardware
• Keeps covers and brackets safely in place

• Disconnect power before servicing; for gas appliances, also shut off gas supply
• Match one-for-one with the original screw; verify length/type before installation
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Use the correct driver bit to prevent stripping the screw head

This replacement screw secures appliance panels, brackets, and internal components. It restores a tight, rattle-free fit and proper alignment when an original fastener is missing, stripped, or corroded.

• Fastens metal or plastic parts to the cabinet/frame
• Helps maintain alignment and reduce vibration or rattling
• Direct replacement for lost, damaged, or rusted hardware
• Keeps covers and brackets safely in place

• Disconnect power before servicing; for gas appliances, also shut off gas supply
• Match one-for-one with the original screw; verify length/type before installation
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Use the correct driver bit to prevent stripping the screw head