Parts for Electrolux E30WD75ESS1: 03 - Body Parts

8-18 x 0.500 mounting screw for appliances. Secures panels, brackets, and components. Replace if stripped, missing, or damaged during repairs.

Burner won't turn off or element light stays on? This range burner control switch regulates temperature and power. Moderate DIY repair, 30-60 minutes.

Secures burner switch to mounting bracket for reliable control. Prevents switch misalignment causing stuck or unresponsive burners. Easy 10-minute fix.

Range won't heat or overheats? This safety thermostat protects against excessive temperatures. Direct replacement part for reliable operation.

Hold down clip secures your warming drawer to the range body. Replace if drawer sags or doesn't stay in position. Verify fit with your model number.

This snap bushing is a push-in panel grommet that protects and secures wiring where harnesses pass through metal or plastic panels. It prevents chafing and helps keep wire routing neat for safer operation. What it does:

• Cushions and shields wires from sharp panel edges to reduce abrasion and shorts
• Secures wiring harnesses in place to prevent unwanted movement or snagging
• Provides a finished, vibration-resistant pass-through for electrical leads
• Commonly replaced when the original bushing is cracked, broken, or missing

• One snap bushing

• Disconnect power before servicing electrical components
• Press-fit into the panel hole until the bushing snaps into place; confirm a secure fit
• Replace if brittle, torn, or deformed; do not use a damaged bushing
• Use pliers for removal if needed; avoid forcing or enlarging the hole

This mounting bracket secures internal components or panels to restore proper alignment and reduce noise. It's a simple replacement that helps stop loose or vibrating parts and keeps service panels and assemblies held firmly in place. What it does:

• Provides a secure attachment point for a panel, trim piece or internal assembly
• Prevents rattling or vibration caused by loose hardware
• Restores proper alignment of removable panels and helps maintain component spacing
• Common symptom: loose or shifting panels, rattling during operation, or visible gap at seams

• Disconnect power (unplug unit or switch off circuit) before starting any repair
• Remove access panels as needed to reach the bracket; keep all original fasteners for reinstallation
• Use appropriate hand tools; avoid overtightening screws which can strip threads or deform the bracket
• If the bracket secures electrical components, secure connections before restoring power

Specs: 10-32 X 0.375

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.

Secures panels, brackets, and internal components in your refrigerator. Replace when the original fastener is missing, stripped, or corroded for proper fit.