Parts for Ge DPGT650GH0MG: 03 - Drum, Motor & Blower Parts

Replacement drum support roller assembly for dryers. Supports and stabilizes the drum as it rotates. Replace if roller is loose, wobbly, or worn out.

A lower-rack lifter that secures and guides the dishwasher's bottom rack for smooth movement and correct positioning. Restores proper rack height and alignment so dishes load, wash, and drain without interference. What it does:

• Supports and raises/lowers the lower dish rack to the correct operating position
• Keeps the rack aligned on its track to prevent binding or rough movement
• Reduces rack rubbing against tub walls and helps ensure proper spray-arm clearance
• Commonly replaced when the rack drops, won't stay level, or moves unevenly

• Disconnect power and turn off water supply before servicing dishwasher
• Remove lower rack to access and replace the lifter; no special tools typically required
• Verify proper seating on the rack guide and smooth operation before returning unit to service
• If other rack components are damaged, inspect for worn wheels or track issues

Transfers motor rotation to tumble clothes. Replace when belt shows wear, breaks, or causes slipping noise. Confirm fit with your model number.

Front drum bulkhead for your dryer. This structural component forms the front of the drum assembly. Replace if cracked, damaged, or worn from use.

Replacement lamp cover for your dryer's interior light. This plastic cover protects the bulb and lens. Order now if yours is cracked, broken, or missing.

Dryer door gasket seal creates an airtight barrier to prevent heat loss and improve efficiency. Replace if worn, cracked, or causing poor drying. Verify fit with your model number.

Connector assembly for dryer stack kits. Secures stacked washer and dryer units together. Replace if connector is cracked, broken, or missing hardware.

Duct assembly that channels hot air from the dryer drum to the exhaust vent. Replace if cracked, disconnected, or showing heat damage or wear.

Color: white. Measures about 12-1/2 inches wide by 11 inches high.

Replacement suspension spring for dryers. Supports the drum assembly and maintains proper alignment. Install when original is broken, stretched, or missing.

Fix a dryer that won't start or hums without turning with this micro switch. Common repair for door latch and control issues. Simple installation.

Dryer mounting screw secures panels, components, or brackets. Replace if stripped, missing, or damaged during disassembly. Essential hardware part.

Lock washer for dryers. Secures bolts and fasteners throughout the dryer assembly. Replace if washer is missing, damaged, or no longer grips properly.

Small metal washer used in various dryer assemblies. Replace if original is lost, worn, or damaged during repairs to ensure proper fit and spacing.

Replacement nut for dryer assembly. Secures components and panels throughout your dryer. Order a new nut if the original is stripped, missing, or damaged.

This is a hot surface glow bar igniter used in gas dryers to ignite the burner flame. It heats up until it reaches the temperature needed to open the gas valve and light the burner. Replace this part if the dryer runs but produces no heat, takes excessively long to dry clothes, or if the igniter glows but fails to ignite the gas.

Dryer door seal prevents heat loss and improves efficiency. Replace if torn, cracked, or causing poor drying performance. Confirm fit with your model.